Yamaha MT400 Bedienungsanleitung Seite 9

E
INPUT-FLIP switch
This switch is used to select the destination of the signal input from the MIC/LINE INPUT
jacks and the tape signal. With the switch in the MIC/LINE position (
input signal is fed to the ST bus via the input channel and the tape signal is fed to the CUE
bus.
With the switch in the TAPE position (
ST L (ST R) bus and the tape signal is fed to the ST bus via the input channel.
Musical instrument
signal input from
MIC/LINE INPUT jack
GAIN
LINE MIC
HIGH
–12 +12
MID
–12 +12
LOW
–12 +12
To ST bus
and tape
MIC/
TAPE
LINE
INPUT-FLIP
When INPUT-FLIP
switch is MIC/LINE (
F
PAN control
This rotary control is used to adjust the stereo position (left or right) of input channel signal
that will be sent to the Stereo bus. For recording via the Stereo bus (See page 22), turn this
control all the way to the left to assign the signal to odd tracks (1, 3), and all the way to the
right to assign the signal to even tracks (2, 4). For mixdown you can use it to pan the playback
signal in the stereo mix.
G
Fader
For recording ([INPUT-FLIP] switch: MIC/LINE), use the fader to adjust the level of the
input channel signal that is recorded to a track. For mixdown ([INPUT-FLIP] switch: TAPE),
use it to adjust the playback level of each track. Unity gain is obtained when the fader is
positioned about the 7–8 mark.
Unity gain :
), the MIC/LINE input 1, 3 (2, 4) signal is fed to the
MT400 tape
signal
MIX CUE
0 10
To CUE bus
)
The condition where the output signal and input signal are at the same level,
with signal-to-noise ratio and distortion set to optimum.
), the MIC/LINE
Musical instrument
signal input from
MIC/LINE INPUT jack
MT400 tape
GAIN
LINE MIC
HIGH
–12 +12
MID
–12 +12
LOW
–12 +12 MIX
To ST bus
and tape
MIC/
TAPE
LINE
INPUT-FLIP
When INPUT-FLIP
switch is TAPE (
—Owner's Manual
7
signal
CUE
0 10
To ST bus
)