Stereo Inputs; Monitor/Master Section - Yamaha MT400 Bedienungsanleitung

8

Stereo Inputs

H
LEVEL controls
These rotary controls are used to adjust the level of the
stereo input signals that are input at the STEREO
INPUT jacks 5 and 6 or 7 and 8. These signals are
usually sent to the Stereo bus for mixing with Input
Channel 1–4 signals and tape signals.

Monitor/Master Section

I
MONITOR LEVEL control
This rotary control adjusts the level of the monitor
signal that is sent to the MONITOR OUT
PHONES
J
Monitor select switch
This switch is used to select the signal source for the
MONITOR OUT
STEREO ... This position selects the Stereo bus and
ST+CUE .... This position selects the Stereo bus and
CUE ........... This position selects the CUE bus as the
K
STEREO fader
Use this fader to adjust the level of the stereo signal
that is sent to the STEREO OUT jacks. Unity gain is
obtained when the fader is positioned about the 7–8
mark.
—Owner's Manual
h
jacks.
m
and PHONES
allows you to monitor the STEREO
OUT signal.
the CUE bus as the monitor source.
monitor source.
7
Unity gain : See Fader.
m
and
h
.
5 –6 7 –8
L R L R
LEVEL LEVEL
8
0 10 0 10
MONITOR/PHONES
LEVEL
9
STEREO
ST+CUE
CUE
MIN MAX
J
STEREO
10
9
8
7
6
5
4
3
2
1
0
K