Herunterladen Diese Seite drucken

Fcc Information (U.s.a.) - Yamaha MY16-AT Bedienungsanleitung

Digital i/o card
Vorschau ausblenden Andere Handbücher für MY16-AT:

Werbung

安全上のご注意 
ここに示した注意事項は、 製品を安全に正しくご使用いただき、 あなたや他の人々への危害や損害を未然に防止するためのものです。
注意事項は、 危害や損害の大きさと切迫の程度を明示するために、 誤った取り扱いをすると生じることが想定される内容を 「警告」 と 「注
意」 に区分しています。 いずれもお客様の安全や機器の保全に関する重要な内容ですので、 必ずお守りください。
* お読みになった後は、 取扱説明書とあわせて、 使用される方がいつでも見られる所に必ず保管してください。
記号表示について
記号は、危険、警告または注意を示します。
記号は、禁止行為を示します。記号の中に具体的な内容が描かれているものもあります。
記号は、行為を強制したり指示したりすることを示します。記号の中に具体的な内容が描かれているものもあります。
この表示内容を無視した取り扱いをすると、死亡や重傷を負う可能性が想定されます。
警告
カードを取り付ける前に取り付ける機器本体がこのカードに対応
しているか、あるいは他のヤマハまたはサードパーティー製の
カードと組み合わせて何枚まで挿入可能かを、機器本体の取扱説
明書またはヤマハのウェブサイトで必ずご確認ください。
Yamaha ウェブサイト:
http://proaudio.yamaha.co.jp/
ヤマハがご案内していない組み合せでヤマハ機器本体に一枚ある
いは複数のカードを挿入した場合、感電や火災、または故障の原
因になります。
MY16-AE/AT/TD はオプション I/O カード (YAMAHA MY シ
リーズおよびサードパーティー製 ) に対応したヤマハ製品の内、
以下のモデルではご使用いただけませんので、ご注意ください。
該当モデル : 01V、AD824、AW2816、AW4416、D24、
DA824、DIO8、DME32、SREV1
この表示内容を無視した取り扱いをすると、傷害を負う可能性または物的損害が発生する可能性が
注意
想定されます。
カードを持つとき、基板裏の電子部品のリード(金属の足)をさ
わらないように注意する。
手を傷つける恐れがあります。
カードを持つときは、前もって他の金属に触れるなどして、静電
気が起きないように注意する。
静電気はボードの故障の原因になります。
1. IMPORTANT NOTICE: DO NOT MODIFY THIS UNIT!
This product, when installed as indicated in the instructions contained in
this manual, meets FCC requirements. Modifications not expressly
approved by Yamaha may void your authority, granted by the FCC, to use
the product.
2. IMPORTANT:
When connecting this product to accessories and/or
another product use only high quality shielded cables. Cable/s supplied
with this product MUST be used. Follow all installation instructions. Fail-
ure to follow instructions could void your FCC authorization to use this
product in the USA.
3. NOTE:
This product has been tested and found to comply with the
requirements listed in FCC Regulations, Part 15 for Class "B" digital
devices. Compliance with these requirements provides a reasonable
level of assurance that your use of this product in a residential environ-
ment will not result in harmful interference with other electronic devices.
This equipment generates/uses radio frequencies and, if not installed
and used according to the instructions found in the users manual, may
cause interference harmful to the operation of other electronic devices.
The above statements apply ONLY to those products distributed by Yamaha Corporation of America or its subsidiaries.
* This applies only to products distributed by YAMAHA CORPORATION OF AMERICA.
This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
取り付け作業の前に、必ずこの「安全上のご注意」をよくお読みください。

FCC INFORMATION (U.S.A.)

MY16-AE/TD を DM2000 または 02R96 でご使用になる場合
は、本体のシステムソフトウェアが下記のバージョン以上である
必要があります。
DM2000: version 1.14 以上、02R96: version 1.06 以上
システムソフトウェアのバージョンアップについては、ヤマハの
ウェブサイトをご覧ください。
カード上の基板部分やコネクター部に無理な力を加えたり、分解
したり改造したりしない。
感電や火災、または故障などの原因になります。
カードを取り付ける前に、必ず取り付ける機器本体の電源プラグ
を抜く。
感電の原因になります。
不適切な使用や改造により故障した場合の保証はいたしかねます。
また、データが破損したり、失われたりした場合の保証もいたしかね
ますので、ご了承ください。
Compliance with FCC regulations does not guarantee that interference
will not occur in all installations. If this product is found to be the source
of interference, which can be determined by turning the unit "OFF" and
"ON", please try to eliminate the problem by using one of the following
measures:
Relocate either this product or the device that is being affected by the
interference.
Utilize power outlets that are on different branch (circuit breaker or fuse)
circuits or install AC line filter/s.
In the case of radio or TV interference, relocate/reorient the antenna. If
the antenna lead-in is 300 ohm ribbon lead, change the lead-in to co-
axial type cable.
If these corrective measures do not produce satisfactory results, please
contact the local retailer authorized to distribute this type of product. If
you can not locate the appropriate retailer, please contact Yamaha Cor-
poration of America, Electronic Service Division, 6600 Orangethorpe
Ave, Buena Park, CA90620
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme à la norme NMB-003
du Canada.
– 4 –
(class B)

Werbung

loading

Diese Anleitung auch für:

My16-aeMy16-td