Connecting To Sdi Equipment - Blackmagic Design Design 3G-Sdi Arduino Shield Installations- Und Betriebs-Anleitung

Connecting to SDI Equipment

With power supplied, you can now plug your Blackmagic Arduino shield into your
SDI equipment. For example, to plug into a switcher and a Blackmagic URSA Mini:
1 Plug the program output from your switcher to the Blackmagic Arduino shield's
SDI input.
2 Plug your Blackmagic Arduino shield's SDI output into the 'program' SDI input marked
PGM on your Blackmagic URSA Mini.
A connection diagram is provided below.
Switcher
That's all there is to getting started!
Now that your shield is mounted to the Arduino board, powered, and connected to your SDI
equipment, you can install the internal software and library files, program the Arduino software
and begin using the shield to control your equipment.
Continue reading the manual for information on how to install the shield's internal software, and
where to install the Arduino library files so the shield can communicate with your Arduino.
TIP You can also use your Blackmagic 3G-SDI Arduino Shield to control other
Blackmagic Design products, such as Blackmagic MultiView 16. For example,
when your shield is connected to input 16, you can display a tally border on the
multi view.
SDI IN
SDI OUT
Blackmagic 3G-SDI Arduino Shield
SDI 'PGM' Input
Blackmagic URSA Mini
Getting Started 7