HBM FIT-AED-KIT Betriebsanleitung Seite 8

8
4 Diagram for startup
For the pin assignment and similar of the AED / FIT, please refer to the appro-
priate operating manual.
The diagram includes the below components:
Power supply
D
PC with USB and COM port, with AED_Panel32 (V3.x.x) software installed
D
PEAK-USB adapter for the CAN bus / DeviceNet)
D
SUB-D9 connection cable (for connecting the diagnosis bus)
D
AED9401A with AD103C or FIT with CAN bus / DeviceNet
D
Transducer for AED9401A
D
Starter KIT card
D
The AED / FIT is supplied by the power supply of the Starter KIT.
The PEAK converter is supplied by the USB port of the PC.
The designations of the terminals (UB, GND, OUT1...4, IN1, IN2, CANH,
CANL) are identical to those of the AED / FIT and have to be connected di-
rectly.
The CANH_out and CANH _in and CANL_out and CANL_in ports respecti-
vely have been connected to each other in the AED / FIT.
PC
COM1
Fig.1: Connecting the AED9401A to the Starter KIT
HBM
Power
supply
24 V
DC
Cable
(SUB-D9)
PEAK-
USB
Adaptor
AED9401A
AD103C
Load cell
Color code (HBM)
BU = blue GN = green
RD = red WH = white
GY = gray BK = black
Transducer / Load cell
OUT1
OUT2
OUT3
OUT4
STARTERKIT
1-FIT-AED-KIT
UB
GND
GND
FIT
OUT 1 OUT 1
Kabel2/
RED RED cable 2
OUT 2 OUT 2
CAN+
OUT 3 OUT 3
OUT 4 OUT 4
CAN−
FIT
Kabel1/ IN1
RA/TA
cable 1
IN2
RB/TB
Cable 1
CAN-Bus, Diagnosis-Bus,
UB / GND, 8 wires
FIT-AED-KIT
IN1
IN2
UB
GND
IN1
IN2
Cable 2
digital I/O, 8 wires
A2022-1.0 de/en