Scope Of Delivery - Hbm Fit-Aed-Kit Betriebsanleitung

FIT-AED-KIT
1 General
The Starter KIT is used for connecting the FIT (CAN / DeviceNet) or
AED9401A (with AD103C) to a PC.
It is intended for initial startup in the laboratory environment only and must
not be used in industrial environments.
The Starter KIT makes the electrical connection to the PC
(CAN bus / DeviceNet / Diagnosis bus).
For the AED / FIT safety regulations, please refer to the appropriate operating
manual.
2 Starter KIT functions
Direct connection of the PEAK-USB adapter for the CAN bus/DeviceNet
D
Bus termination resistor (120 Ω) for the CAN bus
D
Connection of the diagnosis bus (RS-485 2-wire) to a PC-COM port
D
(RS-232), in addition, the Starter KIT includes a level converter (RS-485;
RS-232)
Bus termination resistor (2 x 2 kΩ) for the diagnosis bus
D
2 buttons for the IN1/IN2 control inputs of the AED / FIT
D
4 LEDs for the OUT1...4 control outputs of the AED / FIT
D
Power supply port
D
LED for 24 V voltage supply
D
3

Scope of delivery

Starter KIT card
D
Power supply (100...240 V
D
PEAK-USB adapter
D
Connection cable (SUB-D9)
D
1-FIT-AED-DOC system CD (operating manuals, Panel software)
D
This operating manual
D
The connection cable (SUB-D9) can either be used for connecting the diagno-
sis bus to the PC-COM port or as a connection cable between the PEAK-USB
adapter and the Starter KIT.
A2022-1.0 de/en
, 24 V output, 1.25 A)
AC DC
7
HBM