Playback; Basic Playback Operation; Using The Remote Control - Yamaha YHT-S300 Kurzanleitung

PLAYBACK

Once you have finished all cable connections and remote control operation, follow the procedure below to start basic
playback operation.
1
Press .
This system is turned on and the STATUS indicator
lights green.
y
This system has the auto-sleep function, which will
automatically switch the system to turn off if the system is
left turned on for 24 hours without any operation being
performed.

■ Using the remote control

Use the remote control within 6 m of the
subwoofer integrated receiver and point it toward
the remote control sensor.
Notes
• Be careful not to spill liquid on the remote control.
• Be careful not to drop the remote control.
• Do not leave the remote control in a place that is:
– hot or humid, such as near a heater or in a bathroom
– extremely cold
– dusty
6
En

Basic playback operation

2
1
3
2
4
4
Press one of the input buttons to select an
input source.
Start playback on the selected external
component.
For information on the external component, refer to
the instruction manual for the product.
Press VOLUME +/– to adjust the volume
level.
y
To turn off the volume temporarily, press MUTE. While the
mute function is activated, the VOLUME indicator flashes.
To resume the volume, press MUTE again or press
VOLUME +/–.
Note
When sound of HDMI is output from the TV, the volume
level does not change if you press VOLUME +/–.
Press again to set the system to standby
mode.
When the "HDMI CONTROL" is set to "ON", the
STATUS indicator lights red. When the "HDMI
CONTROL" is set to "OFF", the STATUS indicator
turns off.
Within 6 m