Connecting The Speakers And Antennas - Yamaha htr-3063 Bedienungsanleitung

Connecting the speakers and antennas

1
Preparing the cables and
speakers
Once you've positioned the speakers, you'll need to cut the 25-
meter (82 ft.) speaker cable to make three cables for
connecting the front/center speaker and two cables for the
surround speakers.
1
Cut the included speaker cable to suitable lengths
for the front/center speaker and surround speakers.
You need five cables.
2
Remove about 10 mm (3/8") of insulation from the
end of each speaker cable.
3
Twist the bare wires tightly.
10 mm (3/8")
Good
Notes
• Make the speaker cables as short as possible. Do not bundle
or roll up excess cable.
• Twist the bare wires tightly so the individual strands are not
splayed.
• Be careful not to injure yourself while preparing the speaker
cables.
4
Connect the speaker cables to the front/center
speaker (NS-BR300) and surround speakers
(NS-B285).
Note
• Refer to the SPS-90 Owner's Manual for information on
connecting the surround speakers (NS-B285).
NS-BR300
(front/center speaker)
2
En
■ Attaching the speaker stands
• Front/center speaker (NS-BR300)
If you place the front/center speaker (NS-BR300) at the base of
your TV, attach the included stands. If you use it without the
stands, affix the included non-skid pads.
No Good
• Surround speakers (NS-B285)
Refer to the SPS-90 Owner's Manual for information on
assembling the SPS-90 speaker stands and attaching the
surround speakers (NS-B285).
Attaching the stands
On the rear of the front/center speaker (NS-BR300), there
are four screw holes at each end for attaching the stands at
a suitable height and width for your TV.
Note
• Make sure the front/center speaker does not obstruct
the remote control sensor on the front of your TV.
Screw for the
NS-BR300 stands
550 mm (21-5/8")
695 mm (27-3/8")
Affixing the non-skid pads
Stand
82 mm
(3-1/4")
97 mm
(3-7/8")
Non-skid pads