Troubleshooting; Specifications - Yamaha htr-3063 Bedienungsanleitung

If this product doesn't work as expected, look for a possible cause below. If the issue you are experiencing is not listed, or you cannot
resolve it after reading through these instructions, disconnect the power cable and contact an authorized Yamaha dealer or service
center.
Issue
There's no sound.
The sound is very quiet.
■ Subwoofer (NS-SW280)
Issue
The POWER switch is set to ON but
the subwoofer doesn't work.
There's no sound.
The subwoofer is too quiet.
■ Surround speakers (NS-B285)
Type........................................... Full-range acoustic-suspension
Driver............................................ 6.5 cm (2-1/2") cone speaker
Nominal input power ......................................................... 30 W
Maximum input power ...................................................... 80 W
Impedance ............................................................................... 6 Ω
Frequency response........................................... 110 Hz–40 kHz
Sensitivity ........................................................81 dB/2.83 V, 1 m
Dimensions (W × H × D)
................ 90 × 90 × 109 mm (3-1/2" × 3-1/2" × 4-1/4")
.............. 90 × 120 × 123 mm (3-1/2" × 4-3/4" × 4-7/8")
Weight........................................0.45 kg (1 lbs.) (without stand)
■ Front/center speaker (NS-BR300)
Type........................................... Full-range acoustic-suspension
Driver....................... 4 × 10 cm (1-1/2 × 4 in) cone speaker ×3
Frequency response........................................ 150 Hz to 20 kHz
Impedance ............................................................................... 6 Ω
Dimensions (W × H × D)
NS-BR300 ........... 800 × 50 × 70 mm (31-1/2" × 2" × 2-3/4")
Stand................. 45 × 70 × 88 mm (1-3/4" × 2-3/4" × 3-1/2")
Weight...................................................................... 1.5 kg (3 lbs.)
8
En

Troubleshooting

Possible cause
The speaker cables are not
connected properly.
The speaker cables are not
connected properly.
Possible cause
The power cable is not connected
properly.
The VOLUME control is set to 0. Turn up the VOLUME control.
The subwoofer cable is not
connected properly.
The source material doesn't
contain much bass.
Bass sounds are being cancelled
out by standing waves.

Specifications

non-magnetic shielding type
(without stand)
(with stand)
non-magnetic shielding type
Make sure the speaker cables are connected properly.
Make sure the speaker cables are connected properly:
L (left) to L, R (right) to R, "+" to "+" and "–" to "–".
Set the POWER switch to OFF, then make sure the power
cable is connected properly.
Make sure the subwoofer cable is connected properly.
Try playing source material that contains more bass.
Reposition the subwoofer, or break up parallel wall surfaces
by placing bookshelves or other large objects along the wall.
■ Subwoofer (NS-SW280)
Type ........................ Advanced Yamaha Active Servo Technology
Driver...............................................16 cm (6-1/2") cone woofer
Output power........................ 50 W (100 Hz, 5 Ω, 10% T.H.D.)
Dynamic power ......................................................... 100 W, 5 Ω
Input impedance....................INPUT (1P RCA pin jack): 10 kΩ
Frequency response .............................................30 Hz–160 Hz
Input sensitivity............................. INPUT (1P RCA pin jack):
Power supply
U.S.A. and Canada models ...........................AC 120 V, 60 Hz
Australia model..............................................AC 240 V, 50 Hz
U.K. and Europe models...............................AC 230 V, 50 Hz
Dimensions (W × H × D) ........................262 × 264 × 316 mm
Weight................................................................. 6.9 kg (15.2 lbs.)
■ Speaker stand (SPS-90)
Dimensions (D × H)
.............. Φ 230 × 910 mm (Φ 9" × 35-7/8") (Shortest)
............... Φ 230 × 1200 mm (Φ 9" × 47-1/4") (Tallest)
Weight .............................................................. 2.2 kg (4 lbs 7 oz)
Specifications are subject to change without notice.
Remedy
Remedy
non-magnetic shielding type
80 mV (50 Hz, 50 W/5 Ω)
(10-3/8" × 10-3/8" × 12-1/2")