Safety Instructions For All Applications - Parkside PWS 125 D3 Originalbetriebsanleitung

of moving parts, breakage of
parts and any other condition
that may affect the power tool's
operation. If damaged, have the
power tool repaired before use.
Many accidents are caused by poorly
maintained power tools.
• Keep cutting tools sharp and
clean. Properly maintained cutting
tools with sharp cutting edges are less
Iikely to bind and are easier to control.
• Use the power tool, accessories
and tool bits etc. in accordance
with these instructions, taking
into account the working con-
ditions and the work to be per-
formed. Use of the power tool for
operations different from those intended
could result in a hazardous situation.
Service:
• Have your power tool serviced
by a qualified repair person
using only identical replacement
parts. This will ensure that the safety
of the power tool is maintained.
Safety instructions for all
applications
Common safety instructions for
grinding, sanding, working with
wire brushes polishing and cutting
grinders:
• This electric tool is to be used as
a grinder, sander, wire brush,
polisher and cutting grinder.
Follow all safety instructions,
directives, illustrations and facts
which you receive with the de-
vice. If you do not follow these instruc-
tions, an electrical shock, fire and/or
serious injury may occur.
• Do not use any accessories that
are not specifically intended and
recommended for this electric
tool by the manufacturer. Simply
because an accessory can be attached
to your electric tool does not guarantee
safe operation.
• The allowable rotation speed
of the attachment tools must be
at least as high as the highest
rotation speed indicated on the
electric tool. Accessories that run fas-
ter than the allowable speed can break
and fly apart.
• The outside diameter and thick-
ness of the attachment tool must
correspond to the dimensions
indicated for your electric tool.
Attachment tools which are wrongly
dimensioned cannot be sufficiently
shielded or controlled.
• Attachment tools with threaded
attachment must fit the threa-
ding of the grinding spindle
exactly. For attachment tools
which are mounted through a
flange, the diameter of the hole
in the attachment tool must fit
the mounting diameter of the
flange. Attachment tools which cannot
be precisely attached to the electric tool
turn unevenly, vibrate very strongly and
can ultimately lead to a loss of control.
• Never use damaged attachment
tools. Check attachment tools
such as grinding discs for chip-
ping or cracks, grinding plates
for cracks, wear or strong abra-
sion and wire brushes for loose
or broken wires before using
them. If the electric tool or the
attachment tool falls off, check
whether it is damaged or, use
an undamaged attachment tool.
GB
9