Before First Use; Getting Started - Klarstein 10027875 Bedienungsanleitung

CORRECT USE OF ELECTRICITY
• Use of an extension cord is not recommended as it may overheat and cause risk of fire. However,
if an extension cord is used, the marked electrical rating of the extension cord should be at least
as great as the electrical rating of the appliance, and the long cord should be arranged so that it
will not drape over the countertop or tabletop where it can be pulled on by children or tripped over.
• To prevent overloading and blowing fuses, ensure that no other high power appliance is plugged
into the same socket, or another socket which is connected in the same circuit.
• DO NOT PUT the cord under the carpet, blankets. Always keep the power cable away from walkway
in room. DO NOT TRY TO REPAIR the broken fuse by yourself, the user should take the set to your
local authorized maintenance center to replace it with the new one.
• The appliance is indoor use only.
• This appliance is not intended for use by persons (including children) with reduced physical, sen-
sory or mental capabilities, or lack of experience and knowledge, unless they have been given
supervision or instruction concerning use of the appliance by a person responsible for their safety.
• Children should be supervised to ensure that they do not play with the appliance.
• The surfaces are liable to get hot during use
• Appliances are not intended to be operated by means of an external timer or separate remote-
control system
• When the appliance is not in use and before cleaning, unplug the appliance from the outlet.
• WARNING: If the surface is cracked, switch off the appliance to avoid the possibility of electric shock.
• The outer surface may get hot when the appliance is operating and first time use, there is a little
smoke and smell, that is normal.
SAFETY IN OPERATION
• DO NOT OPERATE this hot plate near water sources or flammable liquids.
• DO NOT OPERATE this hot plate on or near any hot surface. (Hot plate, ectric stoves etc).
• Always operate this from an earthed domestic 220V-240 ~ 50/60 Hz power socket.
• Ensure the hot place is placed on a stable, secure surface to eliminate the possibility of tipping
over or avoid any water in the appliance.
• Never try to touch the hot surface of this hot plate before it is cooled down.
• Clean the hot plate with a soft damp cloth. Place your hot plate on the level and stable surface near
the electrical socket. Check that the voltage marked on the product corresponds with your supply
voltage. Ensure the controller is in the "OFF" position before plug in.
• Always use flat bottom saucepans or containers that make close contact with the heating element.
Ideally, the saucepans or containers should be 180-200mm in diameter. Keep the surface of the
heating element clean and dry.
• Close supervision is extremely necessary when this hot plate is used by or near children.
• or invalids. Never operate this hot plate unattended.
• Put water and/or food in the container (The total amount of water and /or food should not exceed
80% of the container to avoid overflowing), put a lid on the container and place it on the hot plate.
If there is smoke for the first use, that is normal. To make the unit heat without any pot about 10
Minutes before cooking.
• Connecting to the power supply socket. Turn the switch from "OFF" TO "MAX" position and the
indicator light is on for working, the hot plate is in a state of heating.
• Two points to be reminded by the user when using the new hot plate:
• When using this hot plate for the first time, there may be a smell of smoke coming from the surface
of the heating element. This is normal because of the invisible protective coating in production.
• Before the water is boiling, the indicator light on the hot plate may be temporary off due to the
temporary disconnection of the thermostatic control.
• This is a safety issue for the working on the hot plate.
• When you have finished using the hot plate, turn the switch to "OFF" position and unplug it from
the socket. Wait until the appliance is completely cooled down before moving or cleaning.

Before first Use

Getting Started

6