Herunterladen Inhalt Inhalt Diese Seite drucken

Filter Element Replacement; Accessories - Beko S040 Installation Und Betriebsanleitung

Filter mit gewindeanschluss
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Filter element replacement

• Where appropriate, close shutoff valves at gas inlet
and outlet.
• Depressurize the housing.
• Undo the screw (1) of the slide (2). In the case of a
sound signal, the housing is still under pressure! Open
the slide (2) after depressurization.
• Unscrew the bottom (3).
• Remove the old filter element (4) and insert new one.
Note: the upper end cap must be installed according
to the inclination in the element seat.
• Close the housing, look the slide (2) in position and
screw down.
• Slowly admit pressure to the filter by gradual opening
of the shutoff valves.
• Make a note of the date of the next element replace-
ment on the maintenance schedule and the label
supplied with the elements. Stick the label on a part of
the filter housing where it can easily be seen. Reorder
new elements and, where appropriate, a new floattype
drain to ensure an adequate stock of spare parts (see
Appendix, Fax Request).

Accessories

Differential-pressure gauge
Differential-pressure gauges are used to determine the
condition, i.e. the degree of fouling, of the filter elements.
The scaling on the display field also allows an energy
cost analysis.
See page 20 "Accessories"
CLEARPOINT S040 - M032
english
Caution:
The flow travels in the
oopsite direction through
the dust filters R(x).
(as is also shown on the
supplementary sheet la-
beled "spare element")






Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis