Beko CLEARPOINT HP50S040 W Installation Und Betriebsanleitung Seite 6

Content:
Introduction
These instructions for installation and operation will help
you to become more familiar with the CLEARPOINT
and enable you to utilize the device within the intended
scope of application. Furthermore, the instructions con-
tain important information for ensuring safe, correct and
economic operation.
The individual directions have to be followed precisely
as described in order to avoid hazards or damage. Ad-
ditionally, it will be necessary to observe the accident
prevention regulations valid in the operator's country and
at the place of installation together with the approved
rules of engineering practice concerning correct safety
and work procedures.
A long filter lifetime will only be achieved if the notes,
stipulations and maintenance rules in the Instructions
for Installation and Operation are carefully observed.
All persons carrying out the installation, commissioning,
maintenance or repair of the product on the operator's
premises must have read and understood these instruc-
tions for installation and operation. The instructions
should be permanently available at the place of instal-
lation.
6
english
Introduction ................................
Guarantee .................................
Safety rules ................................
Areas of application .....................
Function ....................................
Economic efficiency of filters ..........
Installation .................................
Filter element replacement .............
Technical data ............................
Guarantee
CLEARPOINT water separators and filters are built ac-
cording to the state of the art and the approved safety
rules of engineering practice. However, the use of the
product can endanger the health & life of attending
personnel or third parties and can have a considerable
negative effect on the product itself or on other material
assets if:
-
-
-
This can render the guarantee invalid.
The devices are designed for gaseous neutral fluids of
group II according to PED 97/23/EC up to a maximum
pressure of 50 bar. The fluids must be free from any
aggressive substances. Non-observance of this condi-
tion excludes all liability claims.
In the interest of further development,
BEKO TECHNOLOGIES reserves the right to implement
changes at any time, while retaining the essential fea-
tures of the device, if such changes become necessary
to enhance the technical capacity of the device or for
reasons of safety or standard commercial practice.
6
6
7
7
7
8
8
9
18
the personnel is not properly trained,
the product is used for purposes other than
the intended application,
the device is not correctly serviced or main
tained.
CLEARPOINT S040 - M023 HP 50