Technical Data - EINHELL BT-MR 550 Originalbetriebsanleitung

Anleitung_BT_MR_550_SPK7:_
GB

5. Technical data

Rated voltage
Power rating
Rotational speed range (L) low
Rotational speed range (H) high
Morse taper in spindle
Max. drill bit diameter
End-routing cutter diameter
Face-routing cutter diameter
Compound table
Max. table adjustment in x
Max. table adjustment in y
Max. spindle stroke
Angle adjustment l/r
Protection type
Weight
Sound and vibration
Sound and vibration values were measured in
accordance with EN 60204-1.
L sound pressure level
pA
K uncertainty
pA
L sound power level
WA
K uncertainty
WA
Wear ear-muffs.
The impact of noise can cause damage to hearing.
Warning!
The specified vibration value was established in
accordance with a standardized testing method. It
may change according to how the electric equipment
is used and may exceed the specified value in
exceptional circumstances.
The specified vibration value can be used to compare
the equipment with other electric power tools.
The specified vibration value can be used for initial
assessment of a harmful effect.
Keep the noise emissions and vibrations to a
minimum.
Only use appliances which are in perfect working
order.
Service and clean the appliance regularly.
Adapt your working style to suit the appliance.
Do not overload the appliance.
18
28.02.2011 10:08 Uhr Seite 18
Have the appliance serviced whenever
necessary.
Switch the appliance off when it is not in use.
230 V ~ / 50 Hz
Wear protective gloves.
350 W
0-1100 min -1
Residual risks
0-2500 min
-1
Even if you use this electric power tool in
MK 3
accordance with instructions, certain residual
13 mm
risks cannot be rules out. The following hazards
16 mm
may arise in connection with the equipment's
construction and layout:
30 mm
1. Lung damage if no suitable protective dust mask
390 x 90 mm
is used.
220 mm
2. Damage to hearing if no suitable ear protection is
100 mm
used.
280 mm
3. Health damage caused by hand-arm vibrations if
-45° - +45°
the equipment is used over a prolonged period or
IP2x
is not properly guided and maintained.
50 kg
6. Starting up
Important!
Pull out the power plug before carrying out any
assembly and adjustment work.
To avoid damage in transit, always transport the
machine upright and preferably in the original
82 dB(A)
packaging.
3 dB
Make allowance for the weight of the machine!
93 dB(A)
The net weight of the machine is 50 kg. Use
suitable means of transport that can support the
3 dB
weight of the machine. Should no means of trans-
port be available, lift the machine carefully so as
to avoid injury to people and damage to the
machine itself.
Protect the machine against moisture and rain.
The machine may only be installed and used in
dry, well-ventilated rooms. The temperature range
for operating the machine should be between +15°
and +40°.
Are the tool chuck and routing cutter sufficiently
secure?
Check to see if any parts of the machine have
worked loose.
Has the right rotational speed range been
chosen?
Are the machine and clamping devices clean and
free of chips?
Check to make sure that the fixing screws of the
concentric chuck have been tightened and that the
work spindle can be easily rotated by hand.
All covers and safety devices must be properly
fitted before the machine is switched on.
The jaw chuck must be able to run freely.
Before switching on, make sure that everything
has been properly assembled and that moving