Technical Specifications - Dell PowerVault MD3600i Handbuch Zum Einstieg

Technical Specifications

Drives
PowerVault MD3600i
PowerVault MD3620i
RAID Controller Modules
RAID controller modules
Back-Panel Connectors (Per RAID Controller Module)
iSCSI connectors
SAS expansion connector
Serial connector
Management Ethernet connector
Up to twelve 3.5-inch SAS hot-swappable
hard drives (3.0 Gbps and 6.0 Gbps)
Up to twenty four 2.5-inch SAS
hot-swappable hard drives (3.0 Gbps and
6.0 Gbps)
• One or two hot-swappable modules
with temperature sensors
• 2 GB of cache per controller
Two 10 GB iSCSI IN connectors to
connect hosts
One SAS OUT port for expansion to an
additional PowerVault MD1200 series
enclosure.
NOTE:
SAS connectors are SFF-8088 compliant.
One 6-pin mini-DIN connector
NOTE:
For technical support use only.
One 100/1000 Base-T port Ethernet for
out-of-band management of the enclosure
NOTE:
The default management port IP
addresses for the primary and secondary RAID
controller modules are 192.168.128.101 and
192.168.128.102, respectively. By default, the
management ports are set to Dynamic Host
Configuration Protocol (DHCP). If the controller
is unable to get an IP address configuration
from a DHCP server within a specified time out
period (approximately 3 minutes), it defaults
back to static IP addressing. For more
information, see the Deployment Guide.
Getting Started With Your System
17