Herunterladen Inhalt Inhalt Diese Seite drucken

AEG Electrolux PERFECT DB 50 Serie Gebrauchsanweisung Seite 12

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 1
822 949 308 DB_5020_5040.book Seite 12 Mittwoch, 26. Oktober 2005 4:58 16
g
• Please check the mains cord from time
to time for damage! Special tools are
required to repair a damaged mains
cord. If the supply cord is damaged, it
must be replaced by the manufacturer,
its service agent or similarly qualified
persons in order to avoid a hazard.
Repairs to this appliance may only be
carried out by qualified service engi-
neers. Considerable danger may result
from improper repairs. If repairs
become necessary, please contact the
Customer Care Department or your
authorised dealer.
Technical Data
Power consumption:
• 2200 W (DB 5040)
• 2000 W (DB 5020)
Mains voltage: 220 - 240 V
This appliance complies with the follo-
;
wing EU Directives:
– 73/23/EEC of 19.02.1973 "Low
voltage directive", including modifi-
cation directive 93/68/EEC.
– 89/336/EEC of 03.05.1989 "EMC
directive", including modification
directive 92/31/EEC.
Using for the First Time
Setting the Temperature
(Figure 2)
Please note the internationally appli-
cable care symbols on garment labels.
On good quality garments they indi-
cate the correct ironing temperatures.
The ironing table indicates which tem-
perature is most appropriate for a par-
ticular type of fabric. We recommend
sorting the washing first. Start with
materials that require low temperature
ironing (e.g. PERLON). Follow on by
ironing materials that require progres-
sively higher temperatures. In this way
you avoid damaging sensitive fabrics
by using too high a temperature. When
switched on, the power indicator lamp
12
lights up (Figure 1/J); it goes out when
the temperature set has been reached.
However, if the temperature selector
(Figure 1/N) is turned back, please note
that it takes a while for the soleplate
to cool down. Only when the power
indicator light comes on again has the
soleplate reached the cooler tempera-
ture.
Dry Ironing
0 Set the steam selector (Figure 1/F) to
position "0" (Figure 4/A).
0 Turn the temperature selector
(Figure 1/N) to the desired tempera-
ture.
Steam Ironing
Filling the Steam Iron (Figure 3)
The water reservoir should only be fil-
led when the plug has been removed
from the socket.
0 Set the steam selector to position
"0" = dry iron (Figure 4/A) and hold
the appliance upright.
0 Fill the water reservoir at most to the
"MAX" mark. To do this, you can use
the measuring beaker supplied
(Figure 1/P).
Water Quality
You can use tap water up to 3 mmol/I
17° dH water hardness level. Your local
Water Authority can advise you on the
hardness of the water in your area. If
the water from your tap is harder than
the above, please use distilled water
available from a chemist or a 50:50
mixture of tap water and distilled
water. Never use battery water under
any circumstances!
When using for the first time,
please note:
0 Fill the reservoir with water; set the
steam selector (Figure 1/F) to position
"4" (Figure 4/B).

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis