Tamiya F103GT Bedienungsanleitung Seite 21

1/10th SCAL E
RIC CAR BODY PARTS SET
ez—J1'R
CAUTION
'Read carefully and fully understand
the instructions before commencing
assembly.
'When assembling this kit, tools in-
cluding knives are used. Extra care
should be taken to avoid personal
injury.
'Read and follow the instructions
supplied with paints and/or cement, if
used (not included in kit).
•Keep out of reach of small children.
Children must not be allowed to put
any parts in their mouths, or pull vinyl
bags over their heads. Sensibly dis-
pose of the leftover parts immediately.
Trimming
*Cut Off using scissors or a modeling knife.
061502015 TAMIYA
NISSAN
Launch version
Trimming
*Make 6.5mm holes.
Body
*Cut away.
Fin, side plates
*Make 2mm holes.
*Cut away.
*Make
Side plate
*Cut away.
*When using antenna, make 6mm hole matching the position of antenna.
o
*Make 2mm hole.
Fin
2mm holes.
Side plate
747 (L)
Fin
*Make 2mm hole.
1
NISMO
(6m)
*Make
*Make
*Make
*Cut away.
*Make 2mm holes.
73•y-j»
Wing and flap
*Make 3mm holes.
*Cut away.
*Make
73 y-y
* Cut away.
51579 GT-R LM Nismo LaunchVer Body (11054731)
ITEM 51579
TAMIYA
2mm holes.
4.5mm hole.
4.5mm hole.
Wing
2mm holes.