The power supply unit can be placed anywhere inside or outside of the
snail fence (pasture fence) by plugging it into the ground.
Then a clamp is connected to one of the middle stainless steel wires,
whereby the current plus / minus is transmitted to all conductor tracks.
Important: Never connect a contact to the middle and a contact to
the outer conductor track (permanent short circuit).
Picture right:
Picture wrong:
Preparation and control:
The success rate in installing our fence is very high and it can be
increased by following the following rules:
Attention! Important!
After demarcating the area, please search for the plants within the fence,
as one or the other snail may have been trapped and continue to pursue
its feeding instincts. It is best to spread a few lettuce leaves as bait on the
fenced off area in the evening and then pick up the snails in the light of
the torch about an hour after dusk. Unfortunately, it can still happen that
snail eggs are still in the ground. To be on the safe side, you should
regularly pick up the snails or young snails for about 2 weeks and only
then start the final planting. You can also do a daily inspection after
planting in the evening and search the plants for snails.