EMAG EMMI-DENTAL PROFESSIONAL Bedienungsanleitung Seite 13

English
Intended Use
The products may only be utilised for cases of application intended in the catalogues and the technical descriptions, i.e.
for cleaning teeth, and only in conjunction with external devices and components recommended or approved by EMAG
AG. Any other use or additional use is not considered to be the intended use.
In the event of unintended use, EMAG AG does not assume any liability for possibly arising damages and no guarantee
for fl awless and correct functioning of components.
Observance of all details in the operating instructions also belongs to intended use. The symbol on the
identifi cation plate refers to this.
The fl awless and safe operation of products presupposes appropriate transport, storage, installation and assembly as
well as careful operation and maintenance. The recurring tests in accordance with the German Occupational Health &
Safety Regulation BGV A3 are to be heeded.
The device must be installed so that the charging station's power plug is freely accessible at any time.
Improper Use
Dangers to life and limb as well as dangers to property can arise with improper use of the product. Improper use is
prohibited for this reason. In the event of unintended use, EMAG AG does not assume any liability for possibly arising
damages and no guarantee for fl awless and correct functioning of components. In order to preclude an improper use of
the device, the following details are to be observed:
Ÿ The ultrasonic device for dental micro cleaning may only be operated with the mains voltage which is
printed on the identifi cation plate (underside of the charging station).
Ÿ Do not use any combustible or aggressive chemicals (acids, etc.) for cleaning.
Ÿ If transport damages are detected, do not connect the charging station to the mains.
Ÿ The device may only be operated in interior rooms at room temperature.
Operating Instructions
IMPORTANT before initial use:
Before using, connect the charging station's plug with the outlet, insert the handpiece into the charging station and charge for
approx. 24 hours.
While the handpiece is inserted in the charging station, the red LED display below the switch on the handpiece is
illuminated in order to show that the device is fl awlessly charging (display also illuminates when batteries are fully
charged and the handpiece is put back on the charging station; in the process, the charging is automatically turned off ).
Remove the handpiece from the charging station and insert an ultrasound attachment vertically from above (please
make sure that the ultrasound attachment is inserted vertically, and is also removed vertically upward in order to
prevent damage to the contact pins of the handpiece; do not tilt!). Briefl y wet the bristles of the ultrasound attachment
under running water, and apply Ultrasound Toothpaste to the bristles (approx. twice the size of a pea).
Please note: Use only Emmi-dent Ultrasound Toothpaste, since commercially available toothpastes do not enable a formation
of microcavities (micro-bubbles).
Turn the device on. The ultrasound is generated in the ultrasound attachment directly above the bristles and is
controlled through the electronics in the handpiece. After turning the device on – without ultrasound attachment – you
will feel a vibration. This means that the electronics of the handpiece are functioning fl awlessly. The green LED display
below the switch on the handpiece is not illuminated. With inserted ultrasound attachment – device turned on – the
green LED display below the switch is illuminated and thus shows that the ultrasound generator is functioning with
the proper frequency and fl awlessly. If the green LED display is not illuminated, the ultrasound attachment can have
a poor contact or no contact with the pins of the handpiece or can be defective. In this case, use another ultrasound
attachment and contact our service department because of the defective attachment.
After turning the device on you will feel a slight vibration and hear a faint noise. This has nothing to do with the
cleaning! Since one does not see, hear and feel ultrasound, a small motor has been integrated in the handpiece so that