Example Session - Dell N20 serie Handbuch Zum Einstieg

Example Session

This section describes a Dell Easy Setup Wizard session. The following
values are used by the example session:
• The SNMP community string to be used is public.
• The network management system (NMS) IP address is 10.1.2.100.
• The user name is admin, and the password is admin123.
• The IP address for the VLAN 1 routing interface is 10.1.1.200 with a
subnet mask of 255.255.255.0.
• The default gateway is 10.1.1.1
The setup wizard configures the initial values as defined above. After
completing the wizard, the switch is configured as follows:
• SNMPv2 is enabled and the community string is set up as defined above.
SNMPv3 is disabled by default.
• The admin user account is set up as defined.
• A network management system is configured. From the management
station, you can access the SNMP, HTTP, and CLI interfaces. You may also
choose to allow all IP addresses to access these management interfaces by
choosing the (0.0.0.0) IP address.
• An IP address is configured for the VLAN 1 routing interface.
• A default gateway address is configured.
NOTE:
In the example below, the possible user options or default values are
enclosed in [ ]. If you press <Enter> with no options defined, the default value is
accepted. Help text is in parentheses.
26
Getting Started Guide