Yamaha MCR-750 Bedienungsanleitung Seite 34

USING USEFUL FUNCTIONS
• In order to make the HDMI control function available, set up
settings for the HDMI control function on ALL components
(this unit, TV, and other components). Certain operation may
also be required.
• Each function may be set independently to activate/deactivate
depending on the TV.
• Refer to the operation manuals supplied with the TV for details
regarding setup.
■ Setting the HDMI control function
1
Turn on all components connected to the TV with
HDMI.
2
Check all components connected with HDMI and
enable the HDMI control function on each
component.
For this unit, set [HDMI Control] to [On] (p. 34).
For external components, refer to the manual
supplied with each component.
y
• The default setting of [HDMI Control] is set to [Off] for
this unit.
• The example of TV settings
– From a setup menu on your TV, select "Link setting" =
"HDMI control setting" (example), then set a setting
such as "HDMI control function" to "ON" (example).
– Setting such as "Speaker priority" should be set to "AV
amplifier".
3
Turn off the TV and then turn on it again.
■ Registering HDMI components to TV
1
Select this unit as the input source of the TV.
2
Select Disc/USB/Network as the input source of this
unit.
3
Check that the image from this unit is correctly
displayed on the TV.
4
Check that the HDMI control function works (turn on
this unit or adjust the volume level using the TV
remote control).
y
For some HDMI components, you only need to set the HDMI
control function. Registering HDMI components to TV is not
required in this case.
30
En
If the HDMI control function is not working
Check the following:
• The TV is connected to the HDMI terminal of this unit.
The HDMI control function is set to [On] in SETUP
menu (p. 34).
• The HDMI control function is enabled on the TV. (Also
check the relative settings such as power interlock
function or speaker priority.)
The HDMI control function is not working even
checking the above
• Turn off this unit and the TV, and then turn them back
on again.
• Unplug the AC power supply cable of this unit, the TV
and external components connected to the TV with
HDMI.
Plug them in again after about 30 seconds.
■ Changing the connection method and
connected components
When the connected components and jacks are changed,
reset this unit with following procedures.
1
Turn off the HDMI control function of the TV and
this unit, turn off all connected devices, and change
the connections.
2
Perform the step 1 to 3 of "Setting the HDMI control
function" (p. 30).