Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Power on/off： Long press the button for �.� seconds to power on/off.
Restore the default settings： Long press the button for � seconds when it
is powered off. The bike light will flash rapidly three times, indicating a
successful reset. Please note that resetting will clear all personal settings
and data, so please operate with caution.
Switch light modes： After powering on, single click the button to cycle
through the gears in the sequence of high brightness steady - medium
brightness steady - custom - day flash - night flash - comet flash - waterfall
flash - light off;
After powering on, double click the button to turn on/off the radar;
It can also be adjusted by iGPSPORT bike computer and the APP.
Smart memory： The light will automatically remember the lighting mode
and start operating at the same mode as before when powered on each
time.
RADAR DETECTION
�.The radar can detect vehicles within a distance of about ��� meters behind.
�.The radar can detect approaching vehicles with relative speeds between �
and ��� km/h.
Note: The radar will not detect vehicles traveling at the same speed as you or
vehicles moving away from you.
�.Radar detection range: Horizontal detection angle of ±��.�°, vertical
detection angle of ±��.�°.
�.The radar can detect up to eight approaching vehicles.
�.The radar cannot be used indoors.
CHARGING INSTRUCTIONS
When charging, please follow the steps below:
.Remove the weather cap, insert the charging cable into the USB Type-C
port.
.After charging is finished, please disconnect the charging cable and
securely close the weather cap to maintain the waterproof performance
and normal use of the bike light.
Note:
* From completely depleted to full charge, it takes approximately � hours
(�V �A).
* Due to the slow self-discharge of the battery, it is recommended to charge
the light every six months when not in use for a long time to prevent battery
damage.
��
Werbung
