Werbung
Verfügbare Sprachen
Verfügbare Sprachen
3. Hold the spray arms under a tap with running water and
rinse the small nozzle opening.
4. By shaking, larger foreign bodies (e.g. pieces of
eggshells) can be removed through the connection
opening.
5. Clean nozzle openings with warm soapy water and a soft
brush.
➢ Blockages in the holes of the spray arms disrupt the water flow and
Cleaning the filter
THE FILTER SYSTEM IS STRUCTURED AS FOLLOWS.
1. Turn the coarse filter anticlockwise
and lift the filtersystem upwards.
4. Rinse all filters under running
water and clean with a cleaning
brush.
Check the filters after each use and clean as necessary. Clean at least after every fifth
use, but at least once a month as follows. It is essential to follow the instructions for
saving energy and water (see chapter Fehler! Verweisquelle konnte nicht gefunden
werden.).
Cleaning the appliance door
•
Clean the door frame with a damp cloth.
•
Never use spray cleaners or the like to prevent water from penetrating the door
lock and electrical elements.
Frost protection measures
If the appliance is located in a place where temperatures are close to or below freezing,
observe the following: Remove the mains plug from the plug socket or switch off the
fuse. Turn off the water tap and unscrew the supply hose. Allow the water to drain from
the supply hose and inlet valve. (Place a vessel under the hose to collect the water.)
Connect the inlet hose to the inlet valve again. Remove the filter from the tray in the
bottom of the dishwasher and draw the water out of the rubber ring using a sponge.
detergent tabs may not dissolve properly.
2. Pull the fine filter away downwards
3. Pull the coarse filter upwards and
detach it from the main filter.
5. Reinstall the filter system in the
reverse order.
6. Position the filter system in its
support and press down.
7. Turn the coarse filter clockwise as
far as it will go (see also arrow
markings).
Werbung
