Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Putting into operation
17
Before putting the appliance into operation, make the following settings and fill the
appliance with regenerating salt, rinsing agent and dishwasher detergent.
17.1 Setting the water hardness
Before putting the appliance into operation for the first time, adjust it once to the local
water hardness. You can obtain this information from the water supplier or on the
Internet.
•
The water softener serves to remove minerals and salts from the water that could
damage the appliance or have an undesirable effect on the dishes.
•
The more minerals and salts your water contains, the harder the water.
The dishwasher is designed so that the amount of salt used can be adjusted according to
the hardness of the water used. This is to optimise and individually adjust salt
consumption.
1. Open the door and switch on the appliance.
2. Press and hold down the "Programme" button within 60 seconds of switching on
the appliance for slightly longer than 5 seconds.
3. The display shows the saved water hardness.
4. Select the appropriate water hardness with the "Programme" button
H3>H4>H5>H6>H1>H2.
5. Press the "ON/OFF" button and save the selected water hardness.
The dishwasher is designed so that the amount of salt used can be adjusted according to
the hardness of the water used. This is to optimise and individually adjust salt
consumption.
Carry out the settings using the following table
Factory setting: H3
WATER HARDNESS
ºdH
ºmmol/l
0~5
0~0.94
6~11
1.0~2.0
12~17
2.1~3.0
18-22
3.1~4.0
23~34
4.1~6.0
35~55
6.2~9.8
1° dH = 0.178 mmol/l (dH: German degree of hardness)
Display
consumption
H1
H2
H3
H4
H5
H6
Salt
(gr./cycle)
0
9
12
20
30
60
Regenerate
all X program
runs *)
NO
10
5
3
2
1
Werbung
