IKEA KULINARISK Bedienungsanleitung Seite 28

ENGLISH
Problem
The lamp does not operate.
There is water inside the
oven.
The steam cooking does not
work.
The steam cooking does not
work.
It takes more than three mi-
nutes to empty the water
tank or the water leaks from
the steam inlet opening.
The display shows F111.
The display shows an error
code that is not in this table.
Steam and condensation
settle on the food and in the
cavity of the oven.
Service data
If you cannot find a solution to the problem
yourself, contact an Authorised Service
Centre.
The necessary data for the service centre is
on the rating plate. The rating plate is on
Possible cause
The lamp is defective.
There is too much water in
the tank.
There is no water in the tank. Fill the water tank.
Lime obstructs the hole.
There are lime deposits in
the oven.
The plug of the core temper-
ature sensor is not correctly
installed into the socket.
There is an electrical fault.
You left the dish in the oven
for too long.
the front frame of the appliance cavity. Do
not remove the rating plate from the
appliance cavity.
Remedy
Replace the lamp.
Deactivate the oven and
wipe the water with a cloth
or sponge.
Check the steam inlet open-
ing. Remove the lime.
Clean the water tank. Refer
to "Cleaning the water
tank".
Put the plug of the core tem-
perature sensor as far as
possible into the socket.
• Deactivate the oven with
the house fuse or the
safety switch in the fuse
box and activate it again.
• If the display shows the
error code again, contact
the Customer Care De-
partment.
Do not leave the dishes in
the oven for longer than 15 -
20 minutes after the cooking
process ends.
28