Clock Functions - IKEA KULINARISK Bedienungsanleitung

ENGLISH
A
B
C
2. Put the second end of the draining pipe
(C) into a container. Put it at a lower
position than the outlet valve (A).
3. Open the oven door and put the
connector (B) into the outlet valve (A).
4. Push the connector again and again
when you empty the water tank.
The tank can have some
water when the display
shows: Water required.
Wait until the water flow from
the water outlet valve stops.

Clock functions

Clock functions table
Clock function
Minute Minder
Duration
End Time
If you set the time for a clock function, the
time starts to count down after 5 seconds.
5. Remove the connector from the valve
when the water stops flowing.
Do not use the drained water to
fill the water tank again.
Heat-up indicator
When you activate a heating function, the
bar on the display comes on. The bar shows
that the temperature increases.
Fast Heat Up Indicator
This function decreases the heat-up time.
To activate the function, hold
seconds. The heat-up indicator alternates.
Residual heat
When you deactivate the appliance, the
display shows the residual heat. You can
use the heat to keep the food warm.
Application
To set a countdown (max. 2 h 30 min). This
function has no effect on the operation of the
appliance.
Use to activate the function. Press
to set the minutes and
To set the length of an operation (max. 23 h
59 min).
To set the switch-off time for a heating func-
tion (max. 23 h 59 min).
17
for 3
or
to start.