Herunterladen Inhalt Inhalt Diese Seite drucken

Additional Safety Instructions For Pneumatic Power Tools; Before Using; Start-Up; Chiselling - Parkside PDMH 4500 A2 Bedienungs- Und Sicherheitshinweise

Druckluft-meisselhammer
Vorschau ausblenden Andere Handbücher für PDMH 4500 A2:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

For breakers, move the cutting tool every few
seconds. Stop the breaker when lifting the tool
to change position, because vibration is high
when pulling up on the handles.
Exposure to vibration may cause damage to
the nerves and disturb blood circulation in hands
and arms.
Wear warm clothing and keep your hands warm
and dry when working in cold environments.
Stop using the device if you experience numb-
ness, tingling, pain or lightening of the skin of
the fingers or hands, and consult a physician.
Do not hold the tool being used with the free
hand, as this will increase vibration.
Additional safety instructions
for pneumatic power tools
Air under pressure can cause severe injury:
– always shut off air supply, drain hose of air
pressure and disconnect tool from air supply
when not in use, before changing accessories
or when making repairs;
– never direct air at yourself or anyone else.
Whipping hoses can cause severe injury. Always
check for damaged or loose hoses and fittings.
Cold air shall be directed away from hands.
Do not use quick-disconnect couplings at tool
inlet. Use hardened steel (or material with com-
parable shock resistance) threaded hose fittings.
Whenever universal twist couplings (claw cou-
plings) are used, lock pins shall be installed and
whipcheck safety cables shall be used to safe-
guard against possible hose-to-tool and hose-to-
hose connection failure.
Do not exceed the maximum air pressure stated
on the tool.
Never carry an air tool by the hose.
96912_par_Druckluft-Meisselhammer PDMH 4500 A2_content_IT_PT.indd 41
General safety rules / Before using / Start-up

Before using

Quick-release socket
Pressure regulator
Filter
Lubricator
Quick-opening sleeve
Check the device and tools before every use,
including checking the speed and the vibration
level.
Screw the included plug nipples
connection after first wrapping the thread with
2–3 layers of sealing tape.
Insert the respective chisel into the hex collet of
the chipper. First guide insert the square chisel
into the tension spring. Then slide the tension
spring
over the chisel.
4
Tighten the tension spring all the way onto the
thread of the cylinder. When doing so, hold the
tension spring on the front retainer.
Connect the chipper to a compressor or com-
pressed air supply with suitable output. When
doing so, use a flexible air hose (inside Ø 10 mm)
with quick coupler (see picture shown above).
Be sure the air adjusting screw
air to pass through.

Start-up

Chiselling (see Fig. B / C)
Bring the chipper to the object you wish to
work on.
Activate the trigger
Release the trigger
Quick-release socket
Pressurised air hose
Compressor
into the air
2
9
is set to allow
1
to start the chipper.
3
to switch the chipper off.
3
GB/MT
41
03.06.14 15:07

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Ian 96912

Inhaltsverzeichnis