Instar IN-9820 4K Bedienungsanleitung Seite 27

1 - Wall Bracket
2 - Ceiling Bracket
3 - Antenna Connector
4 - Dual LEDs
5 - Autofocus Lens
6 - Photo Sensor
7 - PIR Sensor
8 - Microphone
9 - Status LEDs
10 - MicroSD card slot
11 - Loudspeaker
12 - Alarm input
13 - Alarm output
14 - WPS / Reset
15 - Network LED
16 - Network Port
17 - Power Connector
18 - Connection Cable
Go to https://install.instar.com
Wall mounting
Overhead installation
RP-SMA WiFi antenna connector
6 high-power IR LEDs (@ 850nm)
6 high-power floodlight LEDs
5x optical zoom lens with autofocus (2.7mm - 13.5mm)
Twilight switch for IR LEDs
Integrated Panasonic passive infrared (PIR) motion detector
For noise detection and audio recording
Red: Camera on or blinking during firmware update
Blue: On during WiFi, blinking during WPS or reset
Slot for MicroSD/SDXC cards (max. 1024GB / 1TB)
- 32GB included inside the camera -
Integrated loudspeaker
Input for potential free external alarm sensors
Potential-free relay for a max. load of 24V/1A
3 seconds for WPS WiFi setup / 20 seconds for reset
Indicator for network status
On: connected to network by network cable
Off: No power, Wifi connection or no network cable connected
RJ45 LAN port for Cat5e LAN cable or higher, for connection
to a router, switch, or PoE switch
For included 12V / 2A power supply
With LAN- and power connector as well as alarm input,
alarm output and reset
6-EN