Acoustic Emission - Astralpool Vs Pool Sicherheits- Und Schnellstartanleitung

WARNING
Before commissioning the product, ensure that the installation is safe and in accordance with local regulations.
WARNING
Comply with the provisions to meet EMC requirements.
WARNING
Use cables of the appropriate type and cross-section according to the electrical characteristics of the load, the ambient temperature and local
regulations.
WARNING
Any insulation tests may only be performed in accordance with the manufacturer's instructions. Failure to do so may result in damage to the unit.
CAUTION
Electronic boards and components may be damaged by electrostatic discharge. We therefore, recommend to don't touch the components.
CAUTION
Take care during installation and electrical connection that no foreign bodies enter into the device.
DANGER
During the entire period in which the device is powered, regardless of whether it is operated or remains in stand-by (digital shutdown), high
voltage is present inside the device and at the input and output terminals.
DANGER
The device, previously in stand-by condition, may suddenly start up following the reset of an alarm or changed system conditions. This may
result in serious mechanical and electrical danger to the operator who, upon seeing the device stopped, may have intervened on it, on the load
or on the system in which it is installed.
DANGER
Disconnect the device from the power supply, check that the load is completely stopped and wait at least 5 minutes before intervening on it or on
the load applied to it.
DANGER
If the motor is of the permanent magnet type, the device may be energized by the passive rotation of the motor. In this case, both the power
supply and the load should be disconnected before working on the device itself.
DANGER
Ensure that the device is fully closed and all fixing screws are properly tightened before supplying power. Do not remove the protective parts for
any reason while the device is powered on.
DANGER
Make sure that the device and the loads connected to it are properly grounded with the appropriate connection terminals before commissioning.
Ensure that the grounding system is compliant and refer to local regulations for grounding devices.
Each load must be fitted with its own earthing cable, the length of which must be as short as possible. Do not make interconnected grounding
connections.
Leakage currents may exceed 3.5 mA. It is recommended to use the reinforced ground connection if necessary.
CAUTION
During operation, some surfaces may reach high temperatures that may cause burns upon contact with skin. Be very careful when touching the
device!
Avoid contact with flammable products.
WARNING
Do not place any interrupting or switching devices between the inverter and the load. Interruption or switching during motor operation may cause
serious damage to the device.
WARNING
Do not perform insulation tests on the load or power cable without first disconnecting them from the device.
DANGER
Only a MAXIM AstralPool three-phase pool pump can be connected to the inverter output; The inverter is not designed to operate other types of
load.
DANGER
Do not immerse the appliance in water or mud.
DANGER
Failure to comply with warnings may cause serious damage to pool equipment or result in serious injury, up to death.

2.4. Acoustic emission

The device has an acoustic emission:
VS POOL
15