Intex Krystal Clear C2500 Bedienungsanleitung Seite 11

OPERATING INSTRUCTIONS (continued)
Operating the system under "TIMER" mode or manually:
To operate the filter pump under "TIMER" mode:
1. Activate the unit:
Press button. Flashing code "00" appears on the LED display, indicating
that the unit is ready to be programmed.
2. Set operating hours:
With code "00" flashing, press
operating hours. See the "Operating Time Table" for the required
operating hours related to each pool size. Pressing
increase the time from 01 to 12 hours maximum. If you have
selected too many hours keep pressing
The built-in timer will now activate the filter pump, at the same
time each day, for the number of hours you have set.
3. Lock keypad controls:
With the desired hours showing, press
buttons.
NOTE: If you forget to lock the keypad controls, the system will automatically lock it and start
working 10 seconds later.
The filter pump is now filtering the water and will stop after the operating hours are
completed.
4. Readjust operating time if necessary:
The operating hours can be re-adjusted if necessary. Press
to unlock the keypad and the current programmed time will flash. Repeat steps 2 to 3.
5. Stand-by/power saving mode:
• When the cycle ends, the LED display shows "00". The system
is now in Stand-By mode. After 5 minutes the system goes into
Power Saving mode and the LED display shows ".". The system
will automatically turn itself back on in 24 hours.
• While the system is in Power Saving mode, press any button
and the system will briefly display the programmed time and then
"00".
To view the TIMER preset hours:
While the pump is operating, press
seconds and then display back the remaining operating hours.
To operate the filter pump manually (without the "TIMER" mode):
1. To run the pump alone without the "Timer", press
pump, then press
the TIMER is off and the pump is now operating continuously.
2. To stop the pump, press
SAVE THESE INSTRUCTIONS
(110) MODEL FP634 FILTER PUMP ENGLISH 7.5" X 10.3" PANTONE 295U 08/23/2024
button to set the desired
to repeat the cycle.
button until you hear a "beep" to lock the control
button, the display will briefly flash the preset hours for 10
button until the LED displays "FP", this indicates that
button again.
will
(1 to 12 hours max per cycle)
button until you hear a "beep"
button to turn on the
110
English
A
Page 11