Herunterladen Inhalt Inhalt Diese Seite drucken

Electrolux 12-107 Anleitungshandbuch Seite 38

Vorschau ausblenden Andere Handbücher für 12-107:
Inhaltsverzeichnis

Werbung

5
01949
Turn the ignition key to "START position".
NOTE!
Do not run the start motor more than 5 sec onds at once. If
the engine will not start, wait about 10 sec onds before the
next try.
Zündschlüssel auf "START" drehen.
HINWEIS!
Den Anlasser nicht jeweils länger als ca. 5 Sekunden betäti-
gen. Wenn der Motor nicht anspringt, vor dem nächsten
Anlaßversuch ca. 10 Sekunden warten.
Let the ignition key return to the "ON" position when the en-
gine has started and push in the choke control as soon as
the engine is running smoothly. Push the gas control to the
re quired speed. For cutting: full gas.
Nach Anspringen des Motors den Zündschlüssel in die Stellung
"ON" zurückgehen lassen. Den Kaltstarthebel zurückschieben,
so daß der Motor gleichmäßig arbeitet. Den Gashebel auf die
gewünschte Motordrehzahl stellen. Bei Mähen: Vollgas.
Amener la clé de contact sur la position "Démarrage"
("START").
REMARQUE!
Ne pas laisser tourner le démarreur plus de 5 secondes à
chaque fois. Si le moteur ne démarre pas immédiatement,
attendre une dizaine de secondes avant d'effectuer une
nouvelle tentative.
Ponga la llave de encendido en la posición de arranque
"START".
NOTA!
No haga funcionar el motor de arranque más de unos 5
segundos a la vez. Si el motor no arranca, espere unos 10
segundos antes de hacer otra tentativa.
Girare la chiave su "START".
NOTA!
Non inserire il motorino di avviamento per più di 5 secondi
per volta. Se il motore non parte attendere una decina di
secondi prima di riprovare.
Draai de startsleutel naar "START"-positie
N.B.!
Laat de startmotor niet langer dan ca 5 sek. per keer draaien.
Als de motor niet start, wacht dan ca 10 sek voordat u vol-
gende poging doet.
Laisser ensuite la clé revenir sur sa position "On" lorsque le
moteur a démarré et repousser la commande de starter dès
que le moteur tourne régulièrement. Amener la commande
des gaz à la position correspondante au régime moteur désiré.
Pour la tonte, positionner cette manette dans l'encoche prévue
pour obtenir le régime optimal pour la tonte (accélération
maximale du moteur).
Dejar que la llave de encendido vuelva a la posición "ON"
cuando ha arrancado el motor e introducir el estrangulador
tan pronto como el motor funcione con regularidad. Ponga
el acelerador en la posición deseada. Al cortar, a plenos
gases.
Dopo l'avviamento, riportare la chiave su "ON". Regolare il gas
sul regime desiderato. Per il taglio: massimo regime "F".
Draai de startsleutel terug in "ON"-posotie, wanneer de motor
is gestart en schuif de choke in zordra de motor gelijkmatig
loopt. Schuif de gashendel naar het gewenste toerental. Bij
maaien: vol gas.
38

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis