Herunterladen Diese Seite drucken

Troubleshooting; Mise En Service - Conrad TE988 Bedienungsanleitung

19-vga-monitor 95khz
Vorschau ausblenden Andere Handbücher für TE988:

Werbung

9. Troubleshooting

By purchasing this monitor, you have acquired a reliable, state-of-the-art product.
Nevertheless, problems or trouble are not excluded. Thus, we would like to describe
how you can eliminate any malfunctions which might occur:
It is essential to adhere to the safety provisions!
Problem
Check:
No image
- Is the monitor or the PC switched ON?
- Is the socket outlet energized (mains voltage)?
- Is the VGA connector inserted correctly into the VGA adapter?
- Perhaps the computer has crashed?
- Is the monitor being used within the intended specifications
(frame / line frequency)?
- Are one or several pins of the 15-pole VGA connector bent?
- Has the power management been activated?
Image is
Adjust the image correctly in the OSD. The image position,
distorted
width etc. may change especially when varying between diffe-
rent resolutions (e.g. change-over from 640*480 to 1024*768
dpi).
Any repair/inspection work exceeding the scope described above
must be performed by an authorized specialist.
34

3. Mise en service

Pour assurer une mise en service correcte, vous devez absolu-
ment lire complètement et attentivement ce mode d'emploi avec
les directives de sécurité avant utilisation !
Connectez d'abord le moniteur puis, par exemple d'autres accessoires par exemple
scanner, imprimante, etc. et en dernier lieu votre PC.
Le moniteur demande environ 10 à 30 secondes pour fournir une image correcte.
Faites attention à ce que la résolution réglée sur votre carte graphique et la fréquen-
ce d'image ne dépassent pas les spécifications du moniteur, voir point 10 des
Caractéristiques techniques.
Lors de la déconnexion de votre système ordinateur, procédez en sens inverse :
après arrêt de votre système d'exploitation, déconnectez d'abord l'ordinateur puis
les périphériques.
4. Eléments de commande sur la partie
avant
Figure 4 : Eléments de commande
1. Interrupteur marche/arrêt
2. LED de puissance
3. Touche de menu OSD
4. Touches de commandes pour OSD et contra-
ste/luminosité
43

Werbung

Kapitel

loading

Diese Anleitung auch für:

99 79 99