Parkside PEKSG 85 D4 Bedienungs- Und Sicherheitshinweise Originalbetriebsanleitung Seite 29

4) Store idle power tools out of
the reach of children and do not
allow persons unfamiliar with the
power tool or these instructions
to operate the power tool. Power
tools are dangerous in the hands of
untrained users.
5) Maintain power tools and
accessories. Check for
misalignment or binding of
moving parts, breakage of parts
and any other condition that may
If damaged, have the power
tool repaired before use.
accidents are caused by poorly
maintained power tools.
6) Keep cutting tools sharp and
clean. Properly maintained cutting
tools with sharp cutting edges are
less likely to bind and are easier
to control.
7) Use the power tool, accessories
and tool bits etc. in accordance
with these instructions, taking
into account the working
conditions and the work to be
performed. Use of the power
tool for operations di erent from
those intended could result in a
hazardous situation.
8) Keep handles and grasping
surfaces dry, clean and free from
oil and grease. Slippery handles
and grasping surfaces do not allow
for safe handling and control of the
tool in unexpected situations.
Service
1) Have your power tool serviced by
identical replacement parts. This
will ensure that the safety of the
power tool is maintained.
˜ Additional safety
instructions
Never use damaged attachment
tools. Check attachment tools
such as grinding discs for chipping
or cracks before each use. If you
have checked the attachment tool
and attached it, keep yourself and
any nearby persons out of the
plane of the rotating attachment
tool and allow the device to run
speed. Damaged tools usually break
during this test period.
any
The allowable rotation speed of
the attachment tools must be
at least as high as the highest
rotation speed indicated on the
power tool. Accessories that run
faster than the allowable speed can
break and y apart.
Ensure that you and all persons
in the vicinity keep out of the
plane of the rotating disk. The
protective guard is designed to
protect the operator from ying
debris and accidental contact with
the abrasive surface.
Grinders may only be used for
the recommended attachment
options. For example: Never grind
using the side surfaces of the
grinding discs. Grinding using the
side surfaces can cause the grinding
disc to burst and y apart.
Always use undamaged clamping
shape for the grinding disc you
selected. Suitable anges support
the grinding disc and thus reduce the
danger of the grinding disc breaking.
GB/IE 29