Remote Control Functions - IKEA Tradfri Anleitung

ENGLISH

REMOTE CONTROL FUNCTIONS

ON/OFF: Press to turn your light source on and off.
Press and hold for at least 3 seconds to synchronize
your lights.
Dim up/down: Short presses will dim up/down in
steps. To dim up/down seamlessly, press and hold
the button.
Change white spectrum, colours or scenes.
Pairing: Add IKEA Smart Lighting products to your
system. See instructions below.
ADDING DEVICES TO YOUR REMOTE CONTROL
When the remote control is sold together with a light
source (in the same package), they are already paired.
If the remote control is purchased separately, you must
manually pair it to your light source.
To add light sources, just repeat the steps below.
1. Make sure that your light source is installed and the
main power switch is turned on.
2. Hold the remote control close to the light source you
want to add (no more than 5 cm away).
3. Press and hold the pairing button
seconds. A red light will shine steadily on the remote
control. Your light source will begin to dim and flash
one time to indicate that it has been successfully
paired.
Up to 10 light sources can be paired with 1 remote
control.
Make sure to pair them one at a time. If the light sources
are close to each other, disconnect those that have
already been paired from the main power switch.
REMOVING DEVICES FROM YOUR
REMOTE CONTROL
1. Make sure the main power switch is turned on for the
2. Hold the remote control close to the light source you
3. Press and hold the pairing button
FACTORY RESET YOUR DEVICES
For light sources:
Toggle the main switch 6 times.
For remote control:
Press the pairing button
for at least 10 SYNCHRONIZING
If your light source becomes unsynchronized, press
and hold the ON/OFF button
to return the light source to its default setting (100%
brightness, 2700K).
light source you want to un-pair from your TRÅDFRI
remote control.
want to remove (no more than 5 cm away).
seconds. A red light will shine steadily on the steering
device. Your light source will begin to dim and flash
twice to indicate that it has been successfully un-
paired.
for at least 10
4 times within 5 seconds.
for at least 3 seconds
22