Using Default Shortcuts; Assigning Custom Shortcuts; Factory Settings; Restoring Factory Settings - Toolcraft Rst-280 Bedienungsanleitung

Menu entry
/Loc
/Loc
1. Press and hold the settings buttons 1 and 3 at the same time until the display shows SET.
2. Navigate to the menu entry using the settings buttons 1 and 3.
3. Use the menu selector buttons TEMP to adjust the value.
4. Save the entry by pressing the settings button 2.
Note:
The locking function does not prevent users from entering the menu and making changes.

10.6 Using default shortcuts

If the soldering iron is in operation, the settings buttons act as shortcuts. The soldering iron is programmed with
three default shortcuts.
Shortcut button
1
2
3
1. Press a shortcut button to switch to the temperature value.

10.7 Assigning custom shortcuts

By assigning custom shortcuts to the settings buttons, you can quickly switch to presets during operation. You can
assign shortcuts to any of the settings buttons.
1. Adjust the soldering iron temperature.
2. Save the shortcut by pressing and holding a settings button (1/2/3) until the values on the display flash once.
3. Use the shortcut by pressing the settings button to which the shortcut is assigned.

11 Factory settings

11.1 Restoring factory settings

Menu entry
/FAC
/FAC
1. Press and hold the settings buttons 1 and 3 at the same time until the display shows SET.
36
Value
ON
OFF
Temperature
200 °C
300 °C
400 °C
Value
OFF
ON
Description
The settings are locked.
The display shows the lock symbol.
The settings cannot be modified.
The settings are unlocked.
The settings can be modified.
Description
If FAC is set to OFF, the settings cannot be restored.
This is a safety feature that prevents accidental restor-
ing.
If FAC is set to ON, the settings can be restored.