Setting Sleep Timers; Activating And Deactivating; Calibrating Temperature; Locking Operational Settings - Toolcraft Rst-280 Bedienungsanleitung

10.3 Setting sleep timers

Set a sleep timer to automatically lower the soldering iron tip temperature after a preset amount of time.
For sleep timers to work, the soldering iron must be in the soldering iron stand. If you pick the soldering iron up
again, the soldering iron tip heats up again to the preset temperature.
Sleep temperature
■
200 °C

Activating and deactivating

Menu entry
/SLP
/SLP
1. Press and hold the settings buttons 1 and 3 at the same time until the display shows SET.
2. Navigate to the menu entry using the settings buttons 1 and 3.
3. Use the menu selector buttons TEMP to adjust the value.
4. Save the entry by pressing the settings button 2.
à
If a timer is set and the sleep time has elapsed, the display shows SLP and the soldering iron tip temperature is
lowered.

10.4 Calibrating temperature

Calibrate a temperature using temperature offsets (Δt) if you have determined that the actual soldering iron tem-
perature deviates from the displayed temperature (tD).
After you set the offset, the displayed temperature is tNew= tD + Δt.
Menu entry
/CAL
/CAL
/CAL
1. Press and hold the settings buttons 1 and 3 at the same time until the display shows SET.
2. Navigate to the menu entry using the settings buttons 1 and 3.
3. Use the menu selector buttons TEMP to adjust the value.
4. Save the entry by pressing the settings button 2.

10.5 Locking operational settings

Lock all settings to prevent accidental modifications to settings. The lock is maintained even after the main unit is
switched off.
Value
OFF
01...60
Value
-50...-01°C
-90...-01°F
-00°C
-00°F
01...50°C
01...90°F
Description
Sleep timer is deactivated
Set a timer in minutes.
Description
Negative temperature offset
Without temperature offset
Positive temperature offset
35