Hot Air Station; Operation Modes; Operating The Hot Air Gun - Toolcraft Rst-280 Bedienungsanleitung

Menu entry
Note:
After you set a password, you cannot disable it by setting the menu entry /Psd to OFF. Remove password pro-
tection by restoring the factory settings. Refer to

9 Hot air station

9.1 Operation modes

Working mode
In working mode, the hot air gun is fully operational.
Standby mode
In standby mode, the hot air gun does not heat or blow air.
Place the hot air gun on the hot air gun holder to activate the standby mode.
Remove the hot air gun from the hot air gun holder to re-activate the hot air gun.

9.2 Operating the hot air gun

Preconditions:
a
You have installed the hot air gun holder.
1. Place the hold air gun onto the hot air gun holder.
2. Switch the main unit on by flipping the power switch I/O to the position I.
3. Wait for the main unit to start up.
4. Switch the hot air gun on by lifting it from the hot air gun holder.
à
The hot air gun heats up.
à
The display shows the actual temperature and REAL (actual temperature).
5. Switch the hot air gun off by placing it onto the hot air gun holder.
à
The hot air gun activates the cooling mode to cool down the nozzle.
à
If the nozzle is cooled down, then the hot air gun stops.
Value
907...999
Restoring factory settings [} 36]
Description
for instructions.
31