Daily Inspection; Engine Starting - Romet CRS 50 Gebrauchsanweisung

4. Daily inspection / 5. Engine starting
GB
Check the following parts on a regular base and before each drive.
Should you notice a defect or a failure, please do not use the
motorcycle and immediately contact an authorized service.
Pos. Part
1 Steering
2 Brake system
3 Tires
4 Fuel
5 Engine Oil
6 Lights
7 Horn
8 Gear Oil
9 Throttle lever
10 All screws
and nuts

Engine starting

Only start the engine after the daily inspection and when the vehicle
is standing on the main stand. You have two possibilities to start the
engine, either with the starting button or with the kickstarter (not for
model CRS 125). Step-by step instruction please see on page 23.
WARNING:
Never push the starting button longer than 5 seconds. Does the motor not
start within this period, please wait another 10 seconds at least before trying
again. Never use the starting button while the motor is running! After a cold
start, please let the motor run for approx. 3 minutes before start to ride.
After the usage of the kickstarter please pay attention, that the kickstarter
will be returned to its original position!
This motorcycle must only be used outdoors.
Inpection content
Flexibility / No gap or loosing appearance
1. Interval between front and rear brake
2. Damages on the cables
3. Wear and tear
Correct air pressure, check for damages
Sufficient fuel
Check for leakages
Sufficient engine oil
Check for leakages
Proper function
Proper function
Oil level
Proper function, easy usage
Returns to initial position
Tight seating
31