Whirlpool ACM 812 WH Gebrauchsanweisung Seite 19

Removing the door
Caution: When carrying out the following operations it is
advisable to wear protective gloves. Carefully follow these
instructions to prevent injury and/or damage to the oven
door and hinges. (Fig. 1)
Pay attention to the oven door hinges: risk of injuring
hands!
Open the oven door
Fully open the saddle brackets
While opening the saddle brackets, use a metal tool such as
handle side of a spoon for easy opening.
Close the door almost completely (Fig. 2), and remove by
pulling it outwards.
NOTE: Proceed in reverse order to refit the door. Make sure the
saddle brackets are lowered before closing the oven door.
Replacing the rear oven lamp:
1. Disconnect the oven from the power supply.
2. After the oven has cooled down, unscrew (anticlockwise)
the lamp cover A (Fig. 3).
3. Replace the lamp (see note).
4. Refit the lamp cover.
5. Reconnect the oven to the power supply.
Note: Only use 25 W/230 V E-14 type T300°C lamps
available from the After-Sales Service.
Important: Do not use the oven until the lamp cover has
been refitted.
saddle
bracket
saddle
bracket
(see detail A)
20
DETAIL A
Fig. 1
Fig. 2
Fig. 3