Attaching/Disconnecting The Battery Pack To/From The Appliance; Checking The Battery Charge Level; Changing/Inserting The Tool/Collet Chuck; Switching On And Off/Setting Speed Range - Parkside PFBS 12 A1 Originalbetriebsanleitung

Attaching/disconnecting the battery
pack to/from the appliance
Inserting the battery pack:
♦ Push the ON/OFF switch
position.
♦ Insert the battery pack
until it clicks into place.
Removing the battery pack:
♦ Press the two battery release buttons
the side of the appliance at the same time and
remove the battery pack

Checking the battery charge level

If the appliance is switched on, the status/remain-
ing charge will be shown on the battery LED 2 as
follows:
RED / ORANGE / GREEN = maximum charge
RED / ORANGE = medium charge
RED = low charge – charge the battery
Changing/inserting the tool/collet
chuck
♦ Press the spindle lock
♦ Turn the tensioning nut
into place.
♦ Undo the tensioning nut
using the combination spanner
♦ Remove any tool which is inserted.
♦ First push the intended tool through the tensioning
nut before inserting it into the appropriate
collet chuck for the tool shaft.
♦ Press the spindle lock
♦ Push the collet chuck
and screw the tensioning nut
combination spanner
│
■ 42 GB
to the "OFF"
into the appliance
on
.
and hold it down.
until the lock clicks
from the thread
.
and hold it down.
into the thread insert
tight with the
.
NOTE
► Use the screwdriver side of the combination
spanner to undo and tighten the screw on
the mandrel .
Switching on and off/setting speed
range
Switching on/setting the speed range:
♦ Set the ON/OFF switch with the speed control
to a position between "1" and "MAX".
Switching off:
♦ Set the ON/OFF switch with the speed control
to the "OFF" position .
Notes on working with materials/
tools/speed range
■ Use the milling bits
iron at maximum speed.
■ Determine the rotational speed range for working
on zinc, zinc alloys, aluminium, copper and lead
by trying it out on test pieces.
■ Use a low rotational speed for work on plastics
and materials with a low melting point.
■ Use a high rotational speed for working on
wood.
■ Carry out cleaning, polishing and buffing work
in the medium speed range.
The following are recommendations only and not
binding. When carrying out practical work, carry
out your own tests to see which tool and which
settings are ideal for the material you are working
on.
for working on steel and
PFBS 12 A1