Herunterladen Inhalt Inhalt Diese Seite drucken

Beko BEKOMAT 14 CO Installationanleitung Und Betriebsanleitung Seite 23

Vorschau ausblenden Andere Handbücher für BEKOMAT 14 CO:
Inhaltsverzeichnis

Werbung

english
Note:
Minimum height of installation
The inflow point must be located lower
than the lowest point of the collecting
tank or vessel.
Note:
ontinuous slope
The feed line must always be laid with a
continuous downward slope. If the space
for installation is too restricted, the lower
feed line must be provided with a sepa-
rate venting line.
Note:
Venting line
In the case of large condensate quanti-
ties, it will always be necessary to install
a separate venting line.
Note:
Continuous slope
It is important to avoid water pockets when
using a pressure hose as a feed line!
Note:
Continuous slope!
Water pockets must also be avoided
when laying a feed pipe.
BEKOMAT 14, 14 CO, 14 CO PN25
français
Important :
hauteur minimale de montage
La hauteur d'arrivée doit être située en-
dessous du point le plus bas du collecteur
(par exemple, la cuve)
Important:
pente continue
La conduite d'arrivée doit toujours être
réalisée avec une pente continue. En cas
de hauteur de montage limitée, utiliser
l'entrée du bas et réaliser une conduite
séparée d'équilibrage d'air.
Important:
conduite d'équilibrage d'air
En cas de forte production de condensat,
il faut toujours installer une conduite sé-
parée d'équilibrage d'air.
Important :
pente continue !
Si l'amenée est réalisée au moyen d'un
flexible, il faut éviter toute "retenue
d'eau" !
Important :
pente continue !
Si l'amenée est réalisée au moyen d'une
tuyauterie rigide, il faut aussi éviter toute
"retenue d'eau" !
nederlands
Belangrijk:
Minimale inbouwhoogte!
De toevoerhoogte dient altijd onder het
aftappunt van de verzamelruimte te liggen
(b.v. ketel).
Belangrijk:
Continue verval!
Het kondensaat moet altijd met verval
(min. 1%) toestromen. Ingeval van een
beperkte inbouwhoogte dient een aparte
ontluchtingsleiding te worden geïnstal-
leerd.
Belangrijk:
Ontluchtingsleiding
Bij grote kondensaathoeveelheden dient
altijd een aparte ontluchtings-leiding te
worden geïnstalleerd.
Belangrijk:
Op afschot monteren!
Wanneer een slang als toevoerleiding
gebruikt wordt, mag er in geen geval een
waterslot ontstaan!
Belangrijk:
Continue verval!
Ook bij het aanleggen van de afvoerlei-
ding een waterslot vermijden.
23

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Bekomat 14Bekomat 14 co pn25

Inhaltsverzeichnis