Alarm Function - Clatronic Mrc 485 Rc Bedienungsanleitung, Garantie

42864-05-MRC 485 RC
5. To switch off the device, shift the function selector to "OFF".
You also have the opportunity of setting to alarm times.
1. Press the MODE button (11) three times. "AL1" appears on the display and the
time starts to flash.
2. Select the desired alarm time with the buttons (1 or 2).
3. Press the SNOOZE button (12) to select the day when you wish to be awaken.
You have two selection options: Mon.-Fri. or Sat.-Sun. (every day).
4. Press the ON/STOP button (10) to activate the alarm function for the first time.
5. To set a further alarm, press the MODE button (11) again. "AL2" appears again
on the display and the time starts to flash. Proceed as described above for the
first alarm.
6. Press the ON/STOP button (10) to activate the second alarm.
After a few seconds the time display appears again automatically.
Radio alarm
• Once the alarm times are set and a radio station has been selected, shift the
function selector to "AUTO".
• As soon as the alarm time is reached, the radio is switched on. The selected
radio station plays at the set volume.
Buzzer alarm
• If you wish to not be waked up with the radio, you can turn the volume knob all
the way to the left until you hear it snap.
• Instead of the radio, the buzzer goes off when the alarm time is reached.
Vibration alarm
The device is equipped with an external vibrator. You can place the vibrator under
your pillow and, when the alarm time is reached, you will be awakened with a soft
vibration.
• Insert the jack of the vibrator in the relevant socket on the back of the device.
• Set the alarm times as described above and shift the function selector to
"REMOTE".
• When the alarm time is reached the vibrator starts to vibrate. You can stop the
vibrator with the incorporated SNOOZE button. After about 15 minutes the alarm
starts again automatically. Press the button again to switch it off for another 15
minutes.
The vibrator's SNOOZE button works also in radio mode! The vibrator is used in
this case as remote control.
09.10.2002 15:07 Uhr

Alarm Function

Seite 13
GB
13