General Specifications - Lifter Py 20 Bedienungs- Und Wartungshandbuch

Thank you for using this weigh scale pallet truck. For your safety and the correct operation of the scale, please
read these instructions carefully before using it.
NOTE:
(1) All the information reported herein is based on data available at the time of printing. The
company reserves the right to modify its own products at any time without prior notice and without
incurring in any penalty. As a result, we recommend always checking for any updates.
(2) Prior to using this weigh scale pallet truck, charge the battery of the scale sufficiently.
1.

GENERAL SPECIFICATIONS

Capacity
Model
PY20 2000 kg
Materials and specifications are subject to change without notice.
2. TILLER INSTALLATION
• Install the tiller (H100) onto the hydraulic unit. Verify that, when positioning the tiller on the pump, the chain
passes through the hole on the tiller foot and tiller pin.
• Rotate the lowering lever (H06) and insert the pin at the end of the chain in its seat. Verify that the tip of the
pin slots properly into the seat.
WARNING: do not remove locking pin before assembling the tiller.
3. ADJUSTING THE CONTROL LEVER
• Put the control lever in position 2 (Lifting) and bring the forks to their maximum height using the tiller, as
illustrated in Fig. 1.
Weighing
Graduation
accuracy
0.5 kg 0.1%
3
Fork size
Length Width over forks
1150mm 540mm
Fork width
160mm