Roger Technology B70/1DC Anweisungen Und Hinweise Für Den Installateur Seite 74

Guaranteed closing and opening enabled.
If the gate is closed as a result of a step mode command, after a period of time set with parameter
If the gate is stopped by the obstacle detection system during a closure manoeuvre, the gate closes after a period of
time set with parameter
If the gate is stopped by the obstacle detection system during an opening manoeuvre, the gate closes after a period of
time set with parameter
Setting safeguarded closure/opening activation time
N.B.: this parameter is not visible if the value of parameter
Wait time settable from 2 to 90 s.
Wait time settable from 2 to 9 min.
Selection of the battery operation management
Setting a value different than
via parameter
The control unit always accepts commands until the battery is completely exhausted. When the battery voltage drops
to the minimum allowed, the message
The command becomes active when the battery voltage drops to the minimum threshold (22V
B71/BC; 24.6V
The command becomes active when the battery voltage drops to the medium threshold (23V
B71/BC; 25V
The command becomes active when the battery voltage drops to the maximum threshold (24V
B71/BC; 25.4V
Selecting the battery operation limitations
N.B.: the parameter is visible only if par.
There is no limitation for the commands when the battery voltage drops under the selected threshold. An error alert may
be activated via the COR output (if parameters
When the battery voltage drops under the threshold selected with par.
commands and does not perform closing.
When the battery voltage drops under the threshold selected with par.
automatically opens the barrier's boom and accepts only a closing command.
It accepts only closing commands (if the ORO input is active, it accepts closing commands only if
When the battery voltage drops to the threshold selected with par.
automatically closes the gate and accepts only one opening command.
Selection of the battery type and consumption reduction
Battery 24V
Battery 24V
Battery 24V
increase battery life
Battery 24V
Restoring factory default values
NOTE This procedure is only possible is NO data protection password is set.
• The default factory settings have now been restored.
Note:
version appears on the display, press and hold down the
74
.
.
a battery voltage level check is activated. The desired operation type can be selected
and an error alert can be activated through the COR output via parameter
is different than
(2x12V ) with B71/BC. Acceleration/deceleration/speed reduction enabled, to increase the battery life.
(2x12V ) with B71/BC. No performance reduction, maximum battery consumption.
(2x12V ) with external charger
(2x12V ) with external charger
Warning! Restoring default settings cancels all settings made previously
except for parameter
P1
are suitable for the installation.
P2
• Press and hold the PLUS + and MINUS - button until the unit switches on.
x4 s
• The display flashes after 4 s
= .
appears on the display (20V with B71/BC battery charger; 23.7V with B71/
and are adequately set).
. Acceleration/deceleration/speed reduction enabled, to
. No reduction in performance. Maximum battery consumption
, ,
(UP ARROW) and
, the control unit
), and then the gate closes.
.
with battery charger
with battery charger
with battery charger
, the control unit accepts only opening
, after a 5 s pre-flashing, the control unit
the control unit, after a prelamping of 5s,
, : after restore, check that all parameters
.
(DOWN ARROW) buttons for 4s.
).