SPL Performer s900 Bedienungsanleitung Seite 4

Performer s900 – Manual
Power up
10
Turn down the volume of the connected preamplifier.
11
Switch on mains switch on the back of the Performer s900 (On = I).
Power LED lights up.
Standby
12
The Standby function requires an AMP CTL connection to an SPL device supporting an AMP CTL
output or a 12V trigger controller.
In standby the Power LED is dimly lit.
Power down
13
Turn down the volume of the connected preamplifier.
14
Switch off mains switch on the rear of the Performer s900 (Off = O).
Power LED no longer lights up.
4