Herunterladen Inhalt Inhalt Diese Seite drucken

Pflegehinweis - Märklin 55247 Bedienungsanleitung

Modell der dampflok mit schlepptender br 24
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 8
Befahren von Steigungen
Im Gegensatz zum Vorbild können mit einer
Modellbahn auch größere Steigungen
befahren werden. Im Normalfall sollte eine
Steigung bei maximal 3 Prozent liegen. Im Ex-
tremfall sind bei entsprechend eingeschränk-
ter Zugleistung maximal 5 Prozent möglich.
Der Anfang und das Ende der Steigung sind
auf jeden Fall auszurunden.

Pflegehinweis

Diese Lok kann auch im Außenbereich ein-
gesetzt werden. Antrieb und Elektronik sind
gegen Spritzwasser geschützt. Wasserdurch-
fahrten sind nicht möglich.
Hinweis: Reinigungsmittel können die Farbge-
bung oder die Beschriftung der Lok angreifen
und beschädigen.
Potentielle Fehlerquellen beim
Rauchgenerator
Der Rauchgenerator darf nur maximal halb
mit Rauchöl gefüllt sein.
Im Rauchgenerator darf sich keine Luftblase
befinden.
Rauchöl 0242
Betrieb auf der Anlage • Operation on a layout • Exploitation sur réseau
Operating the locomotive on grades
In contrast to the prototype a locomotive
on a model railroad can operate up steeper
grades. As a general rule a grade should be
no steeper than 3%. In extreme situations a
maximum grade of 5% is permissible, keeping
in mind that the locomotive's tractive effort
will be less. The beginning and the end of
the grade must always work gradually up to
maximum grade for the route.
Tips For The Care Of Your Locomotive
This locomotive can also be used outdoors.
The mechanism and the electronic circuit
are protected against spraying water. The
locomotive cannot be run through water.
Important: Cleaning fluids can attack the
finish and lettering for the locomotive and
damage them.
Potential Problems with the Smoke
Generator
The smoke generator cannot be filled any
more than halfway with smoke fluid.
There should not be any air bubbles in the
smoke generator.
Smoke fluid 0242
32
Bedrijf op een modelbaan • Funcionamiento del sistema • Funzionamento del sistema
Franchissement des côtes
Contrairement à l'original, la maquette est
également en mesure de franchir des côtes
assez importantes. En temps normal, une côte
devrait étre de l'ordre de 3% maximum. A
l'extrême limite, 5% sont envisageables avec
une puissance du train réduite en conse-
quence. Le début et la fin de la côte doivent
en tous cas étre arrondis.
Remarque sur l'entretien
Cette locomotive peut également être
mise en service à l'air libre. Le moteur et
l'électronique sont protégés contre les pro-
jections d'eau. Des trajets dans l'eau ne sont
pas possibles.
Attention : Certains solvants et produits
d'entretien peuvent altérer le marquage et la
peinture du modèle.
Causes d'erreurs potentielles Avec
le générateur fumigène
Le générateur fumigène ne peut pas être
rempli de liquide fumigène au-delà de la
moitié du tube.
Aucune bulle d'air ne peut se trouver dans le
générateur fumigène.
Liquide fumigène 0242

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis