Lezyne MACRO DRIVE 1400+ Kurzanleitung

QUICK START - MACRO DRIVE 1400+ - ENGLISH
READ ENTIRE MANUAL BEFORE OPERATION to ensure proper use and care of your new Lezyne LED light. Traffic laws mandating
lighting vary from country to country. Inform yourself about lighting laws and regulations in the country Of use. Lezyne LED lights
do not conform to the German road traffic regulation
MACRO DRIVE
Warnings
DO NOT LOOKDIRECTLYINTO LIGHT BEAM or shine into eyes of another.
Lezyne LED Lights have a water resistance rating of IPX7 under IEC standard
the device is not recommended. If moisture does enter the casing, air out until completely dry.
DO NOT ATTEMPT TO REMOVE ELECTRONICS. Doing so will void warranty.
Lezyne USA, Inc. does not accept any liability for injuries or other damages resulting
Of this product in any circumstances.
Warranty
In U.S. and U.K., Lezyne LED Lights carry a two (2) year warranty from the original purchase date to the original owner (proof Of
purchase required). Lezyne Batteries carry a six (6) month
manufacturing defects in materials or workmanship.
installation, attempting to access or modify electronics, damage or failure due to accident, misuse, abuse and/or neglect.
For all warranty issues worldwide, please contact the retailer
For any warranty questions contact: warranty@lezyne.com
Mounting
Operation
1. On/Off: hold button two (2) seconds.
2. Mode cycle: click button
RACEMODE: With the light OFF, hold button for five (5) seconds, until light flashes.
The light is now in Race Mode where only Overdrive and Enduro outputs are selectable.
even when switched OFF.Repeat the step above to return to the normal mode set.
MODE MEMORY: The light remains in the output setting it is switched
THERMAL PROTECTION: If the operating temperature
• Please read all instructions before use
• Lea todas las instrucciones antes de usar
• Veuillez lire les instructions avant utilisation
• Bitte NesenSie vor dem ersten Gebrauch alle Anweisungen durch
Lezyne USA, 645 Tank Farm Rd., Unit F, San Luis Obispo, California 93401
StVZO.
1400+
60529. Submerging
from the use
warranty from the original purchase date. Lezyne warranties
Issues not covered by warranty include normal wear & tear, improper
that sold the product.
The light will remain in Overdrive
OFF in.
of the light is too high, the light automatically lowers the lumen output.
Run Times and Modes
MACRO DRIVE 1400+
gLAsr
200 M50 950
LUMENS LUMENS LUMENS
25:oo 12:30 4:00
h : min h : min h: min
RACE MODE
Battery Indicator
An LED, located in the button, displays current battery status while light is ON. When light is OFF, click button once to momentarily
display battery status.
Illuminates green
Charging
Before using your Lezyne LED Light for the first time, fully charge the battery.
To charge your light:
1. Switch light OFF
cover any
2. Remove USB-C protective cover
3. Connect USB-C cable and light to powered
Once charging, button will flash green; if USB-Cport is capable, light will use High Efficiency (HE)charging
4.
and button will flash blue
If button does not flash when plugged in, selected USB-Cport may not be powered—try another USB-C port.
Light will be charged after 6—8hours (4—6with HEcharging) or when button illuminates solid green or blue.
5. Remove light from charger and reinstall USB-Cprotective cover—ensure USB-Cprotective cover is fully
installed for water resistance
Charging
Flashes
green or blue
Race Mode
1400 700 20 100
LUMENS LUMENS LUMENS LUMENS
3:00 100:oo 300:oo 14:00
h : min h: min h: min h : min
100%
O O O
Illuminates yellow Illuminates red
USB-C port
Fully Charged
O
4
Illuminates
green or blue
5%
Flashes red
For more info go to: www.lezvne.com/support.php
74355-Y17-LED-MACRODRlVE-PLUS-QUlCK-ROB1