Herunterladen Inhalt Inhalt Diese Seite drucken

Safety Advice Relating To Cordless Drill Drivers; Before First Use; Removing / Charging / Inserting Rechargeable Battery Pack; Checking The Battery Status - Parkside PABS10.8-LI Bedienungsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

General safety advice for electrical power tools / Before first use
Safety advice relating
to cordless drill drivers
½
Securely support the workpiece. A work-
piece held in a clamp or vice is kept more se-
curely in place than one held by your hand.
½
WARNING!
Harmful / noxious dusts generated from your
work represent a risk to the health of the person
operating the device and to anyone near the
work area.
½
Wear safety glasses and a dust
mask!
½
Do not drill any material containing
asbestos. Asbestos is a known carcinogen.
½
Hold the electrical power tool firmly.
High reaction torques may occur momentarily
during tightening or loosening of screws.
½
If the inserted tool jams, switch off the
electrical power tool immediately. Be
prepared for high reaction torques as they may
cause kickback. The inserted tool may jam if
the electrical power tool is overloaded or is
held at an angle to the workpiece.
½
WARNING!
strike concealed electricity cables,
therefore when working you must
hold the electrical power tool by the
insulated handle areas only. Contact
with a live wire means that the metal parts of
the electrical power tools may become live and
this can result in an electric shock.
½
Before you carry out any tasks on the
device, transport or store it, make
sure that the direction of rotation
switch is in the middle position (lock).
To prevent the device from starting up uninten-
tionally.
©
Before first use
©
Removing / charging / inserting
rechargeable battery pack
Note: The battery is supplied partially charged.
Charge the battery in the charging station for at
20 GB/MT
POISONOUS DUSTS!
The inserted tool may
least three hours before first use. By doing this the
battery will operate at its highest capacity. You can
charge the Li-Ion battery at any time without risk of
shortening battery life. Interrupting the charging
process does not damage the battery.
1. In order to remove the rechargeable battery pack
8
, press the release buttons
rechargeable battery pack
2. Place the charging cap
battery pack
.
8
3. Place the power supply unit
The status LED
will shine red.
14
4. The green charge indicator LED
that the charging process is complete and the
battery pack
is ready for use.
8
5. Insert the rechargeable battery pack
the device.
©

Checking the battery status

To check the battery status, press the button for
the rechargeable battery LED
diagram). The status or the remaining power
will be displayed in the rechargeable battery
LED
as follows:
3
GREEN / RED / ORANGE = maximum charge /
performance
RED / ORANGE = medium charge / performance
RED = low charge – recharge battery
©

Changing tools

Your cordless drill / screwdriver has a fully automat-
ic spindle lock
.
Once the motor has come to a halt, the drive shaft
is automatically locked, so that the chuck
be opened simply by turning it
After you have inserted the required bit and fixed it
in place by turning the chuck
ately continue working. The spindle lock releases
itself automatically when the motor is started (by
operation of the ON / OFF switch
9
and take the
8
out of the device.
onto the rechargeable
16
into the socket.
13
shows you
15
into
8
(refer to main
2
can
12
.
, you can immedi-
).
6

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis