General Safety Advice For Electrical Power Tools; Workplace Safety - Parkside PABS10.8-LI Bedienungsanleitung

Maximum
drill diameter:
Steel: 8 mm
Wood: 20 mm
Rechargeable battery pack PABS 10.8-LI-1:
Type: LITHIUM-ION
Nom. voltage: 10,8 V
Capacity: 1300 mAh
Power supply unit PABS 10.8 -LI-2:
INPUT:
Nominal voltage: 230 V ~ / 50 Hz
OUTPUT:
Nominal voltage: 12 V
Rated current: 0.6 A
Charging time: approx. 3 hours
Noise / vibration data:
Measured values for noise are determined in accord-
ance with EN 60745. The A-weighted noise level
of the electrical power tool are typically:
Sound pressure level:
Sound power level:
Uncertainty K:
Wear ear protection!
Total vibration (vector sum of three directions) is
calculated in accordance with EN 60745:
Drilling in metal: Vibration emission value a
= 1.944 m / s
D
uncertainty K= 1.5 m / s
Screwing: Vibration emission value a
2.101 m / s
uncertainty K= 1.5 m / s
The vibration level given in these
WARNING!
instructions has been measured in accordance with
a standardised measurement procedure specified
in EN 60745 and can be used to compare devices.
Different uses of the device give rise to different
vibration levels and in many cases they may exceed
Introduction / General safety advice for electrical power tools
70 dB(A)
80 dB(A)
3 dB
h,
2 ,
2 ,
h
2 ,
2 .
the values given in these instructions. It is easy to
underestimate the vibration load if the electrical power
tool is used regularly in particular circumstances.
Note: If you wish to make an accurate assessment
of the vibration loads experienced during a particular
period of working, you should also take into account
the intervening periods of time when the device is
switched off or is running but is not actually in use.
This can result in a much lower vibration load over
the whole of the period of working.
General safety advice
for electrical power tools
WARNING!
and instructions! Failure to observe the safety
advice and instructions may result in electric shock,
fire and / or serious injury.
KEEP ALL THE SAFETY ADVICE AND INSTRUC-
TIONS IN A SAFE PLACE FOR FUTURE REFER-
ENCE! THE TERM "ELECTRICAL TOOL" USED
IN THE SAFETY ADVICE REFERS TO ELECTRICAL
TOOLS POWERED BY MAINS ELECTRICITY (BY
MEANS OF A MAINS LEAD) AND ELECTRICAL
TOOLS POWERED BY RECHARGEABLE BATTER-
IES (WITHOUT A MAINS LEAD).

1. Workplace safety

a) Keep your working area clean and
well lit. Untidy or poorly lit working areas
can lead to accidents.
b)
Do not work with the device
=
in potentially explosive envi-
ronments in which there
are inflammable liquids, gases or
dusts. Electrical power tools create sparks,
which can ignite dusts or fumes.
c)
Keep children and other peo-
ple away while you are op-
erating the electrical tool.
Distractions can cause you to lose control of
the device.
Read all the safety advice
GB/MT 17