YASKAWA LA700 Serie Installation Und Betriebsanleitung Seite 24

Verfügbare Sprachen

For more information about Auto-Tuning, refer to the Technical Manual.

When you use MEMOBUS/Modbus communications to set parameters, set H5-11 = 1 [Comm ENTER Command Mode = ENTER

Command Not Required].

Check before Energizing the Drive

Examine these items before you energize the drive:

• Make sure that all wires are connected correctly. Also make sure that motor phases are connected in the correct

• Make sure that there are no screws, loose wire ends, or tools in the drive.

Figure 1.9 Flowchart for Basic Setup Procedure

YASKAWA TOMPYEULA7002A LA700 Series Installation and Operation Instruction